JOOM A10 True Wireless Stereo Earphones Instructions
- June 6, 2024
- JOOM
Table of Contents
- JOOM A10 True Wireless Stereo Earphones
- Packaging List
- Product Overview
- Power On & Pairing
- Approach 2 – Without Charging Case
- ANC/Transparency Mode
- Incoming call
- Music
- Power Off
- Charging
- Wireless Charging Support
- Safety Instruction
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
JOOM A10 True Wireless Stereo Earphones
Customer Support
US: us_supportcare@163.com
Packaging List
Product Overview
- Charging Case LED Light
- Charging Port
- Reset Button
- Multifunctional Button
- Earphone LED
- Magnetic Charging Pin
- Earphone Microphone
Power On & Pairing
Approach 1 – With Charging Case
Take out earphones from the charging case
Select’A10’from Bluetooth list
Approach 2 – Without Charging Case
Note: Right earphone is the master earphone
Power On: Touch the earphones for 2 seconds with prompt sound ‘Power on’
Pairing: Right earphone Blue and White light flash Select ‘A 10·
ANC/Transparency Mode
Tap Left earphone once to switch between ANC! Transparency mode ANC Mode Prompt Sound: Noise cancelling on Transparency Mode Prompt Sound: Ambient on
Incoming call
Answer call/End call
Tap the Left/ Right earphone once
Reject call
Touch the Left/ Right earphone for 2 seconds
Music
Pause I Play
Tap the Right earphone once
Voice Assistant
Tap the Left/ Right earphone 3 times
Change Song
Double-tap the Left/Right earphone
Adjust Volume
Touch and hold the Left/Right earphone
Power Off
Without Charging Case
Tum off Bluetooth to disconnect the earphones
Touch either one earphone for 8 seconds to power off both earphones
Charging
Earphones:
Earphone LED Light On: Charging
Earphone LED Light Off: Fully Charged
Charging Case:
Charging Case white LED Light on/blinking: Fully Charged/Charging
Note: It takes about 1.S hours to fully charge the charging case
Wireless Charging Support
Put the charging case on the wireless charging pad
Note: It takes about 4 hours to fully charge the charging case
Safety Instruction
- Using earphones at high to moderate volumes for extended periods of time will result in permanent hearing damage. It is advised that you keep volume levels moderate to low at all times for your safety.
- Do not use while driving. cycling. operating machinery or performing other activities that require hearing surrounding sounds.
- Do not use earphones in thunderstorm weather, the earphones may not work properly in the bad weather condition, and may increase the risk of being hit by lightning.
- Earphones may not work properly under high temperature or high humidity conditions.
- Do not use any corrosive cleaner/oil to clean the earphones. If the earphones come In contact with liquids, quickly wipe away. If submersed in the water, do not tum the earphones on until it is completely dried.
- Tips: Man-made damage and lost are not covered under warranty. Keep the earphones and the packaging out of reach of children’s.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 1 5 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, If not Installed and used In accordance with the Instructions, may cause harmful Interference to radio communications.
However, there is no guarantee that interference will not occur in a particular Installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged ta try to correct the Interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment Into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio technician for help.