HF IF16 Wearable Wireless Speaker User Manual

Wearable
Wireless Speaker USER MANUAL

Please expand the user manual to view the detailed usage guide.

What is Included

Product Diagram

Button Control

Music/Phone Call

| Press and hold for 2s| On/Off
| Press X 1| Play/Pause
Press X 1| Answer/Hung up the cal
Press and hold for 2s| Reject call
Press X 2| Dial the lastcall
| Press X 1| Volume up
Press and hold for 2s| Next track
| Press X 1| Volume down
Press and hold for 5S _| Previous track
Bluetooth
**| Press X 1| Connect/Disconnect
| Press and hold for 2s| Clear last paired device
TWS Mode
**| II Press X 2| TWS On/Offe

About Charging

• The working indicator light is always red when charging, and the light goes out when fully charged.
• When the power is less than 50%, the working indicator light is always red and accompanied by a low-power prompt sound, and the volume is automatically reduced by 50%. When the power cannot guarantee the normal operation of the machine, a low-power alarm will be issued once, and the machine will automatically shut down after about 10 seconds.

About TWS Connection

• TWS mode connection method 1
  After the product is connected to Bluetooth, start TWS. After TWS is successfully connected, the blue indicator lights of the two prototypes are always on.

• TWS mode connection method 2
  When the two products are no longer connect- ed to Bluetooth: Product A starts TWS, and Product Bis in the waiting pairing state. After TWS is successfully connected, the blue indicator light of Product A (host) flashes, and the blue indicator light of Product B (sub-machine) is always on. The Bluetooth indicator light of Host A will not become always on until Host A is connected to Bluetooth.

NOTED:
TWS startup prompt-TWS ON
TWS pairing success prompt sound “Ding Dong Dong”

Wearing Method

1. Pick up the device with your hand and press the clip on the back
2. Clip the device to the collar or chest pocket of your shirt

1. Remove the magnet from the back of the device;
2. Place the magnet on the inside of the clothing and the device on the corresponding outside so that the magnet and the device areattached together and fixed on the chest o the Tshirt.

Product Parameters

20H (5% Volume)
Dimension| 44’71’35(mm)
Product Weight| 60g

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.”

RF warning statement

• The device has been evaluated to meet general RF exposure requirement.
• The device canbe used in portable exposure condition without restriction.

FCC STATEMENT:

• This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

Wearing:

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
– This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmfulinterference to radio communictions.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

FCCID:2BGMD-IF16
IC1D:32515-IF16 AIFALLC
Any questions to contact us:
info@ifgear.com

Documents / Resources

| HF IF16 Wearable Wireless Speaker [pdf] User Manual
IF16, IF16 Wearable Wireless Speaker, Wearable Wireless Speaker, Wireless Speaker, Speaker
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>