iKlip Grip Pro User Guide
- June 6, 2024
- IK
Table of Contents
iKlip Grip Pro
Made in Italy
For the complete user manual, visit:
http://www.ikmanual.com/iklipgrippro?SRC=QR
|
---|---
|
|
|
|
|
|
|
|
|
Regulatory
Model: iKlip Grip Pro
Model Number: IK000084
Bluetooth Shutter Model Number: 084-104-1-01 (Contains part SFR1002)
The U.S.A.
Contains Bluetooth shutter with FCC ID : 2ADMCSF2001
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two
conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC radiation exposure statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. End-users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
CANADA
Contains/Content Bluetooth shutter with IC ID: 20638-SFR1002
IC statement/warning
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
To comply with Industry Canada RF radiation exposure limits for the general population, the antenna(s) used for this transmitter must be installed such that a minimum separation distance of 20cm is maintained between the radiator (antenna) and all persons at all times and must not be co-located or operating in conjunction with any other antenna or transmitter
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
EUROPE
AUSTRALIA/NEW ZEALAND
BRAZIL
Modelo: Remote Shutter
04464-15-05139
Technical Specifications
UNITED ARAB EMIRATES
TRA
REGISTERED N°: ER48399/16
DEALER N°: DA45962/15
SINGAPORE
Complies with
IDA Standards
DA00006A
JAPAN
204-520308
CHINA
CMIIT ID: 2015DP5291
KOREA
Shenzhen Kinlan Technology Limited
SFR1002
MSIP-CRM-KIN-SFR1002
2015.10
For warranty information, please visit:
ikmultimedia.com/warranty
ikmultimedia.com/support
STG-IKLIP-GRIPPER-DT -0001
IK Multimedia.
musicians First.
Documents / Resources
| IK
iKlip Grip
Pro
[pdf] User Guide
iKlip, Grip Pro, IK, IK Multimedia
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>