Mardin MCS-108 Mini Chain Saw User Manual

Table of Contents

MCS-108 Mini Chain Saw
User Manual

Mardin MCS 108 Mini Chain Saw - Package Contents

Deo not use this chainsaw to cut thick branches (thicker than 6 om in diameter). The result may be that the biade will deform.
We do not recommend using the chainsaw outdoors in cold or damp weather. This is due to water damage and possible electric shocks that can occur.
If there is insufficient electrical power, check the electrical power coming from the battery.
If the cutting force is insufficient, check whether the blade is blunt.

Prevent injury

Wear protective clothing and work gloves when using this chainsaw.
Before each use, check that the chain runs correctly around the guide plate.
On and off switch must be free to be pressed directly.
If the switch is damaged, stop using the chainsaw immediately.
Make sure that the voltage of the power supply matches the correct amount of voltage that tie chainsaw can handle.
The risk of injury can be reduced by wearing protective clothing and work gloves, as well as making sure that the devices is working properly.

Charge

When the red light on the charger is on, it indicates that the battery is charging. The green ight indicates that charging is complete.
The average charging time is 2 hours.
When charging is complete, simply remove the charger from the battery.

Mardin MCS 108 Mini Chain Saw - Functions

Tarn the holding nut
Loosen the nut counterclockwise and remove the cover
Remove cover
After removing the safety cover (as shown in the picture), you can remove the guide.
Chain guide plate installation
Lay the chain over the guide plate. You know that the chain is correctly positioned when the center guide tooth protrudes through the guide siot of the guide plate.
– Note: the chainring must face forward. This atliows the chainsaw to automatically determine the correct chain tension.
– Note: When mounting the guide plate, make sure that the adjusting block engages in the positioning adjustment hole at the end of the guide plate.
Lay the chain over the guide plate
Note the direction of the incisors. Align the pin hole and install both the reversed hole and the chain.
Mount the guide plate and turn the nut
Place the guide plate on the chainsaw and tighten the nut.

WARNING!

When using the chainsaw for the first time, stretch the chain manually,
You can easily check the correct tension of the chain by gently lifting the chain with your fingers. When 1 to 3 guide teeth are exposed, the tension ‘Ss Correct.
Check and adjust the correct tension regularty. If you do not do this, the chain can easily derail, which can lead to rapid wear of the chain and guide piste.
The chain must be attached to the sprocket. Please check it again after instatlation.

Loosen the compression nut
Set the chain
The adjusting screw is turned clockwise to tighten the chain and counterclockwise to loosen.

Make sure the chainsaw switch is in the “off” position at all times.
Disconnect the battery from the chainsaw.
To ensure safety, onlyoriginal spare parts maybe used during maintenance
Wear work gloves at all times during cleaning and maintenance. This will prevent you from opening your fingers
Cleaning and maintenance should be performed regularly. This ensures long-lasting and reliable operation of the chainsaw.
Keep the chainsaw away tram water. This can cause an electric shock.
Keep the fan, motor section and chain saw handle clean.
Use a damp cloth or cleaning brush.
Clean the blade carefully after each use.
Use an oily cloth to clean and protect the blade at the same time.