LEDCO TS10/NE TESEO Taut Lighting Instructions
- June 6, 2024
- LEDCO
Table of Contents
LEDCO TS10/NE TESEO Taut Lighting Instructions
- Read these instructions carefully before commencing installation and retain for future reference.
- The luminaire should be installed by a licensed electrician and in accordance with local regulations.
- Make sure that the power is off before installation or maintenance.
Parts Needed
-
MANICOTTO
-
GHIERA
-
CILINDRO FILETTATO
Assembly Instructions
-
Locate mark the mounting position of the base. Use an electric drill to
drill holes in the marked position on the wall, and then drive in the expansion rubber plug.
-
Push the base into the round sleeve, and then insert the power cable from one end of the base to one end of the round sleeve.
-
Align the base of the power cord and the round sleeve with the expansion rubber plug, insert the screw, and tighten the screw with a screwdriver.
-
Cut the steel strip according to the distance from the wall,the cutting length of steel strip is 19,5cm shorter than the actual wall.
-
Push the steel strip into the nixing port and tighten the screw with an alien key.
-
Connect the wires, push in the steel belt fastener, and rotate the round sleeve to straighten the steel belt.
-
Place the LED strip on the steel strip and cut off the excess.
-
Connect the power cables of the LED strip to the dedicated power supply.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>