CANARM LBL167A14WAC 14 Inch LED Outdoor Wall Sconce Instruction Manual
- June 6, 2024
- CANARM
Table of Contents
LED OUTDOOR
LIGHTING
LBL167A14WAC 05/21
NEED HELP?
Call or Email us first
Our service team is ready to answer your questions.
1-800-265-1833 (English) /
1-800-567-2513 (French)
IN CANADA – ressalescanada@canarmna.ca –
IN USA – ressalesusa@canarmna.ca
Monday — Friday
8 AM- 5 PM E.S.T
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS READ ALL INSTRUCTIONS
**IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS
**
TOOLS AND MATERIALS REQUIRED:
SAFETY PRECAUTIONS:
- TURN OFF ELECTRICAL POWER BEFORE STARTING THE INSTALLATION OF THE LIGHT FIXTURE.
- THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
- CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL OUTLET BOX.
- NOT FOR USE IN LUMINAIRES CONTROLLED BY A DIMMER.
- TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A CLEAN, SOFT CLOTH.
NOTE: The product may not look exactly as shown in the figures.
INSTALLATION:
**WARNING:** SUITABLE FOR WET LOCATIONS WHEN THREADS ARE SEALED WITH TEFLON TAPE OR PIPE SEAL.
- Run black, white, and green wires from the fixture through the arm.
- Screw the arm onto the shade. Put the backplate and back plate gasket in place. Seal another end of arm into backplate with a gasket in place.
- Connect the ground wires (bare copper or green) from your fixture to the ground wire (bare copper or green) or ground screw in the electrical outlet box. Connect black wire from fixture to black wire in an outlet box and connect the white wire from fixture to white wire in the outlet box.
- Put backplate gasket in place and attach backplate to the junction box using screws provided.
- Align fixture and secure by tightening set screws on the backplate.
- After installation, seal around the top and side perimeter between the fixture and the wall surface with weather-resistant caulking. The bottom hould be left un-caulked to prevent moisture build-up. Apply a small amount of weather-resistant caulking around the side perimeter between the screw and mounting plate.
Warning: Seal around the perimeter between the arm and the shade with weather-resistant caulking.
Tel: 613-342-5424, Fax: 800-263-4598
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>