CANARM IVL1120A01 Willow Bathroom Sconce Light Instruction Manual

Table of Contents

CANARM-IVL1120A01-Willow-Bathroom-Sconce-Light-product

Specifications:

Safety Precautions:

Turn off the electrical power before starting the installation of the light fixture.
Ensure wiring supplies as required by local electrical code.
The product must be installed by a person familiar with construction and operation.
To clean the fixture, turn off the power, wait for it to cool, and wipe with a clean, soft cloth.

Installation:

Attach the Easy ConnectTM mounting bracket to the electrical box using provided screws.
Connect electrical wires from the electric box into the correct inserts on the fixture.
Tuck electrical wires into the box and position the fixture over the studs on the mounting bracket. Secure in place with washers and nuts.
Position the shade on the bulb lamp and secure it with a spinner nut.
Install specified bulb type and wattage (not included).
For multiple green, black, and white wires, attach a single jumper wire before connecting.

FAQ:

Q: Can I use a different type of bulb than specified?
A: It is recommended to use the specified bulb type and wattage for optimal performance and safety.
Q: What should I do if the fixture does not turn on after installation?
A: Double-check all connections, ensure power is turned on, and verify the bulb is properly installed. If issues persist, consult a professional electrician.
Q: Is it safe to clean the fixture while it is still powered on?
A: No, always turn off the power, wait for the fixture to cool down, and then clean it with a soft cloth.

INSTRUCTIONS ABOUT RISK OF FIRE OR INJURY TO PERSONS READ ALL INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS

TURN OFF THE ELECTRICAL POWER BEFORE STARTING THE INSTALLATION OF THE LIGHT FIXTURE.
WIRING SUPPLIES AS REQUIRED BY LOCAL ELECTRICAL CODE.
THIS PRODUCT MUST BE INSTALLED BY THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A CLEAN, SOFT CLOTH.

NOTE: The product may not look exactly as shown in the figures.

Attach the Easy Connect™ mounting bracket to the electrical box with electrical box screws (not included).
Option 1: Connect (push) electrical wires from the electric box (house wiring) into the correct inserts.
Option 2: For multiple green (ground), black (life), and white (neutral) wires joined in the electrical box (house wiring), attach a single “green”, “black” and “white” jumper wire before connecting. Strip 7mm from the 6” jumper wires supplied. Then connect (push) wires into the correct inserts.
Connect (push) electrical wires from the fixture into the correct inserts.
Tuck electrical wires into the electrical box and position the fixture over the studs on the mounting bracket assembly. Secure fixture in place with star washers and cap nuts.
Remove the spinner nut from a socket. Position the shade on the lamp and secure it with a spinner nut.
Install specified bulb type and wattage (not included). $CANARM-IVL1120A01-Willow-Bathroom-Sconce-Light-fig- $4$$