CANARM IPL778B01BKG Pendant Light Instruction Manual
- June 4, 2024
- CANARM
Table of Contents
IPL778B01BKG Pendant Light
PENDANT LIGHT
IPL778B01 10/21
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
TOOLS AND MATERIALS REQUIRED:
Wiring supplies
as required by
local electrical
code
SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
4. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
INSTALLATION:
Note: Determine desired mounting option prior to proceeding with installation.
1. A. INSTALLATION FOR PENDANT MOUNT
i. Install the length of rod that is required by threading wire through the
rod and screwing it to the fixture. Install swivel to the rod, ensuring that
the sleeve is at the swivel.
B. INSTALLATION FOR SEMI FLUSH MOUNT
i. Place the canopy over the nipple on the fixture and secure in place with
the star washer, ground wire and hex nut.
2. Loosen “B”. Adjust stud to desired length and lock in place with “B”.
Mount the mounting bracket to outlet box using electrical box screws (not
included). Make sure the studs on the mounting bracket are facing
out from the electrical box.
3. Connect the ground wires (bare copper or green) from your fixture to the
ground wire (bare copper or green) or ground screw in the electrical box.
Connect the black wire (or wire with marking) from the fixture to the black
wire in the electrical box and connect the white wire from the fixture to the
white wire in the electrical box.
4. Once connections of wires are completed, carefully tuck wires and wire
nuts into the electrical box making sure no bare wire (on the black and white)
is visible at the wire nuts.
5. Position fixture over studs on mounting bracket assembly. Secure fixture
in place with star washers and cap nuts.
6. Remove spinner nut from socket. Position the glass on lamp and secure with
spinner nut.
7. Install specified bulb type and wattage (not included).
Tel:613-342-5424, Fax: 800-263-4598
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>