tc electronic 455073 Shaker Vibrato Guitar Effects Pedal User Guide

: June 6, 2024
: tc electronic

Table of Contents

Controls
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Quick Start Guide
SHAKER VIBRATO

Visit tcelectronic.com to download the full manual

Controls

USB – Connects to your computer for firmware updates and TonePrint editing.
Speed – Adjusts the amount of time between the peaks of the vibrato effect.
Rise time – Adjusts the time it takes for the vibrato to reach the maximum intensity set by the Depth knob.
Output
Footswitch – Turns the effect on and off.
Power – Connect a 9 V / >100 mA power supply.
Depth – Adjusts the intensity of the vibrato effect.
Tone – Shifts the effect’s emphasis toward higher or lower frequencies.
Input
Vibrato type switch – Selects between standard Vibrato on/off, custom TonePrint, and a Latch setting where the pedal is only active when you press and hold the footswitch.

FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION

TC Electronic
SHAKER VIBRATO
Responsible Party Name: Music Tribe Commercial NV Inc.
Address: 5270 Procyon Street,Las Vegas NV 89118, United States
Phone Number: +1 702 800 8290
SHAKER VIBRATO
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

this device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

Important information:
Changes or modifications to the equipment not expressly approved by Music Tribe can void the user’s authority to use the equipment.

Hereby, Music Tribe declares that this product is in compliance with Directive 2014/30/EU, Directive 2011/65/EU, and Amendment 2015/863/EU, Directive 2012/19/EU, Regulation 519/2012 REACH SVHC and Directive 1907/2006/EC.
Full text of EU DoC is available at https://community.musictribe.com/
EU Representative: Music Tribe Brands DK A/S
Address: Ib Spang Olsens Gade 17, DK – 8200 Aarhus N, Denmark