tc electronic Ditto Jam X2 Looper Pedal User Guide
- June 5, 2024
- tc electronic
Table of Contents
tc electronic Ditto Jam X2 Looper Pedal
introduction
Note: When the loop is cleared, DITTO X2 JAM returns to true bypass
Note: When the loop is cleared, DITTO X2 JAM returns to true bypass at band tempo before recording loop
ONBOARD MICROPHONE
NOTE: Using the onboard mics, Ditto X2 Jam should be placed nearer to the percussion source and away from the direct sound of your amp. If this not possible, use external mic clipped directly to a snare drum, cajon, djembe etc.
EXTERNAL MICROPHONE
NOTE: Best results are obtained using the external mic connected directly to the rhythm source. On a drum kit, an undersnare location has proven reliable. Placement inside a Cajon or clipped to a djembe tensioner string near the head are also good positions for the mic.
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION
DITTO JAM X2 LOOPER
FCC Rules
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Important information
Changes or modifications to the equipment not expressly approved by Music
Tribe can void the user’s authority to use the equipment.
Hereby, Music Tribe declares that this product is in compliance with Directive
2014/30/EU, Directive 2011/65/EU
and Amendment 2015/863/EU, Directive 2012/19/EU, Regulation 519/2012 REACH
SVHC and Directive 1907/2006/EC.
Full text of EU DoC is available at
https://community.musictribe.com/
EU Representative: Music Tribe Brands DK A/S
Address: Ib Spang Olsens Gade 17, DK – 8200 Aarhus N, Denmark
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>