Menuett 008058 Blender Instruction Manual

Menuett 008058 Blender Instruction

SAFETY INSTRUCTIONS

• Read all the instructions carefully before use.
• Only intended for household use.
• Check that the mains voltage corresponds to the rated voltage on the type plate.
• Do not allow the power cord to hang over the edge of a table or worktop.
• Do not use the product if it is damaged or not working properly, or if the power cord or plug are damaged. Take the product to an authorised service centre to be checked, repaired or adjusted.
• Do not allow children to use the product without supervision.
• Avoid contact with moving parts.
• Never leave the product unattended when switched on.
• Only use accessories and attachments recommended by the manufacturer. The use of other accessories can result in fire, electric shock and/or personal injury.
• Never attempt to mix hard, dry substances, this will blunt the blades.
• Switch off the product before changing accessories and before touching moving parts when the ice product is in use.
•  Switch off the product (position O) after use. Switch off the product, pull out the plug and wait until all moving parts have completely stopped before taking the product apart.
• This product can be used by children from 8 years and upwards and by persons with physical, sensorial or mental disabilities, or persons who lack experience or knowledge, if they a re supervised or receive instructions concerning the safe use of the product and understand the risks involved with its use. Do not allow children to play with the product. Do not allow children to clean or maintain the product without supervision.
• Keep children under supervision to make sure they do not play with the product.
• Do not immerse the motor unit in water or any other liquid.
• Do not use the product outdoors.
• Do not put the product on or near a hot stove or in a hot oven.
• Make sure the power switch is in the OFF position before plugging in the plug. Switch off the product with the power switch and then pull out the plug.
• Keep your hair, clothing, hands, jewellery and other foreign objects away from moving parts.
• Never run the product with hot liquid, or when it is empty.

WARNINing The blades are sharp – handle them with care.

SYMBOLS

TECHNICAL DATA

• Rated voltage 230 V ~ 50 Hz
• Output 500W
• Volume 1.51
• Size 390 x 202 x 184 mm
• Cord length 0.9 m
• Weight 2.85 kg

DESCRIPTION

1. Lid
2. Size
3. Spout
4. Handle
5. Glass beaker
6. Motor unit
7. Control dial
8. Base
9. Feet

CONTROL DIAL

Mode Explanation

• P Motor pulses.
• 0 Switched off.
• 1 On
• 2 On and a little faster than in mode 1.

Before Using For This First Time

1. Unpack the product and place all the parts on a level surface.
2. Wash the beaker and lid in hot water and washing-up liquid, rinse and wipe dry.

Waring

• The blades are sharp – handle them with care.
• Never immerse the motor unit in water or any other liquid – risk of electric shock.

MIXING FRUIT AND VEGETABLES

1. Check that the control knob is in the “O” position.
2.  Put the beaker on the motor unit with the handle to the right as shown in the diagram.
3. Clean/peel the food to be mixed, cut into small pieces and put them in the beaker. Some water should usually be added for the blender to run smoothly.
4. The proportion of food and water should be 2:3. The total amount must not exceed the 7500ml – 7.51 marking on the beaker.
5. Put the lid on the beaker and twist clockwise until it clicks in place.
6. Plug in the plug.
7. Turn the control dial to the required mode (P, o, 7, 2). Turn the control dial to “P” and hold to pulse the motor for precise mincing. The control dial returns to “O” when it is released.
8. When you have obtained the right consistency, turn the control dial to “O”.
9.  Remove the beaker from the motor unit by lifting it straight up, without twisting.
10. Open the lid by twisting it anticlockwise and then carefully lift it up and pour out the mixture. Note that the seal can produce some resistance to the inside of the beaker. Do not use sharp objects to remove the lid, this could damage both the lid and the beaker.
11. Pull out the plug after use.

WARNING! Do not run the blender continuously for more than three minutes. Allow it to cool for one minute before using again.

IMPORTANT: The beaker must be correctly fitted on the motor unit and the lid must be locked in place so that the hook on the beaker engages with the locking mechanism on the motor unit, otherwise the blender will not start.

NOTE:

• Never add hot water to the blender, or start it when it is empty. The blender can be used to crush ice.
• Check that you have put the lid on properly before starting the blender. Never open the lid during use.

MAINTENANCE

QUICK CLEANING

• Pour a little hot water with washing-up liquid into the beaker and keep the control dial in “P” mode for a few seconds.
• Remove the beaker from the motor unit by pulling it up. Rinse the beaker and lid under running water.
• Wipe the motor unit with a damp cloth.
• Dry all the parts and refit.

COMPLETE CLEANING

• For complete cleaning, release the blades from the base of the beaker by firmly turning the connector on the opposite side clockwise.
• All parts except the motor unit can be washed in a dishwasher at up to 70°C.

NOTE: Do not remove the casing on the motor unit – risk of electric shock. The blender does not contain any parts that can be repaired by the user. Take the blender to an authorised service centre to be checked, repaired or adjusted.

WARNING!

• The blades are sharp – handle them with care.
• Do not use abrasive detergent.
• Never immerse the motor unit in water or any other liquid.

WASTE DISPOSAL
Recycle products that have reached the end of their useful life according to local regulations.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>