savio TG-01 Glacier Thermal Grease User Manual
- June 17, 2024
- Savio
Table of Contents
GLACIER
Thermal grease
SERIES: TG
USER MANUAL
INSTRUKCJA OBSŁUGI
LET’S PLAY 2GETHER!
TG-01 Glacier Thermal Grease
Thank you for choosing Savio product!
If our product meets your expectations, share your opinion withother people on
the portal ceneo.pl, on social media or on thewebsite of the store where you
made the purchase. If you
want to show off our device on SAVIO FanPage on Facebook, we will be very
pleased.
If there is something that we could improve on our products, please write to
us at support@savio.net.pl
Thanks to your feedback, we will be able to better adapt the product to your
expectations.
Before starting the use of purchased device it is recommended to read the
whole manual.
Technical specification*:
| TG-01| TG-02| TG-03| TG-04
---|---|---|---|---
Thermal conductivity:| 4.7 W/m∙K| 8.5 W/m∙K| 13.5 W/m∙K| 14.5 W/m∙K
Working temperature:| -50 — 250ºC| -50 — 250ºC| -50 — 250ºC| -50 — 280ºC
Thermal impedance:| <0.155ºC ∙ in 2/W| <0.135 ºC ∙ in2/W| <0.102 ºC ∙ in2/W|
<0.095 ºC ∙ in2/W
Density:| 2.5 ± 0.08
g/ml| 2.6 ± 0.08
g/ml| 2.9 ± 0.08
g/ml| 2.8 ± 0.08
g/ml
Electrical conductivity:| 0 pS/m| 0 pS/m| 0 pS/m| 0 pS/m
*Depending on the model purchased.
Package content:
- SAVIO GLACIER thermal grease
- User manual
- Spatula for spreading the grease
Applying thermal grease:
3.1 Clean the processor IHS surface and the radiator base with a dry cloth or
Isopropyl Alcohol.
3.2 Spread a thin layer of thermal grease over the processor IHS with a
spatula added to the set. Alternatively, you can apply a 3 × 3 mm drop of the
grease in the middle of the IHS.
3.3 Assemble the cooling system of the processor. The best method is to screw
in the opposite corners of the frame. It allows even spreading of the grease.
3.4 After mounting the cooling system, check if there are no leakages. If
leakages appear, it means that there is too much grease applied. You have to
clean the excess with a dry cloth or Isopropyl Alcohol.
Additional information:
While storing, the grease can discharge trace amounts of silicone oil. That is
normal and does not have any detrimental effect on grease efficiency.
The paste should be re-mixed during the application.
Safety conditions:
- Keep out of reach of children.
- It is forbidden to consume the product.
- In case of contact with the eye, you need to wash your eyes with a substantial amount of water.
- In case of inhaling fumes from the grease, it is necessary to go outside to breathe fresh air for a while.
- In case of ingestion it is not necessary to induce vomiting. Rinse your mouth with plenty of water.
- If you notice any side effects, not mentioned above, please contact medical support.
Information for customers and contractors and communication regarding
complaints:
Pursuant to Article 13 section 1 and 2 of the General Data Protection
Regulation (EU) 2016/679 of the European Parliament and of the Council of 27
April 2016 (hereinafter referred to as GDPR), please be advised that Elmak Sp.
z o.o., with its registered seat at ul. Morgowa 81; 35-323 Rzeszów becomes the
Administrator of your personal data. The Specialist for General Data
Protection (SODO) can be contacted in writing to: SODO, Elmak Sp. z o.o., ul.
Morgowa 81; 35-323 Rzeszów, via e-mail address:
sodo@elmak.pl, and by phone at +48 (17) 854 98 14.
Your personal data will be processed in order to perform the contract, in
accordance with Article 6(1)(b) of the aforementioned regulation, to the
extent resulting from tax laws and financial regulations. Recipients of your
personal data in-clude entities authorized by legal regulations to obtain
personal data as well as processing entities providing services to Elmak Sp. z
o.o. Your personal data will be stored on the basis of Administrator’s
legitimate interest. You have the right to access your data, and the right to
rectify, delete or limit processing of your data. You have the right to lodge
a complaint to the supervisory body if you believe that the processing
violates the GDPR. The provision of personal data is voluntary, however, a
failure to provide such data may result in a refusal to conclude or in
termination of a contract. Your personal data will not be subjected to
automated decision making, including profiling referred to in Article 22
section 1 and 4 of the GDPR of April 27, 2016.
PRODUCER:
Elmak Sp. z o.o.
ul. Morgowa 81
35-323 Rzeszow
www.savio.net.pl
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>