MIIEGO MiiBLASTER XL Wireless Speaker User Guide

MIIEGO MiiBLASTER XL Wireless Speaker

OVERVIEW

1. Volume up / Next song
2. Volume down / Previous song
3. Play / Pause
4. EQ (BASS/ ROCK/ POP/ CLASSIC)
5. Light control button
6. Mode (Bluetooth or AUX). Long press: TWS.
7. POWER button: Power On/ Off. Pairing.
8. Battery indicator – 4 LED lights
9. Powerbank USB-output port
10. Charging Port
11. Reset Port
12. Wired Microphone Port
13. AUX IN

SPECIFICATIONS

Bluetooth v5.0. Rechargeable 5400 mAh Li-ion battery. Full charging time: 7-14 hours. Battery playing time: 3.5-8 hours per charge (depends on volume level). IPX5. BT frequency range: 2.402-2.480GHz. Freq. Response: 50Hz-15 KHz. Charging input power: 5V DC/1A or 2A. RMS audio output: 40W. Impedance: 4Ω.

CARE, MAINTENANCE, SAFETY

Any modification of the product may have consequences for safety, warranty and proper functioning. Keep out of reach for children and animals. Product storage and working temperature: from -5 celsius degrees to +40. Do not expose the product to direct sunlight, heat or naked flames as it may cause damage or explosion. Do not use the product if a part is damaged or defective. Replace a damaged or defective device immediately. Disconnect the product from the electrical outlet and other equipment if problems occur. Do not charge when the product is wet. Do not leave a battery on prolonged charge when not in use. Do not dismantle, open or shred batteries. Do not drop the product and avoid bumping. This product may only be serviced by a qualified technician for maintenance to reduce the risk of electric shock etc.

Pairing your MiiBLASTER XL MIIEGO® Bluetooth speaker

1. Make sure the speaker is charged and turned OFF.
2. Press and hold the power button for 2 seconds until the indicator light flashes Blue (pairing mode).
3. Activate Bluetooth on your phone or other device and search for Bluetooth devices and select: MiiBLASTER XL.
   When MiiBLASTER XL is connected the Blue light is constantly on. The speaker will remember your phone/device and automatically reconnect the next time you turn it on. An unpaired speaker will automatically turn off after 6 minutes.

Charging the MiiBLASTER XL speaker

• Use a 5V/1A or 2A USB adapter for charging.
• During charging the 4 LED battery indicator lights will flash one by one. When fully charged the lights will stay on permanently.
• Full charging time is around 7 hours with 2A and 14 hours with 1A.

Next time charging

• When the first battery LED indicator light is flashing every 5 seconds, the battery status is low and needs charging.
• You will then also hear a battery warning tone every 120 seconds.

Turning Your MiiBLASTER XL On and Off

• ON: Press the power Button for 2 seconds until a tone is heard.
• OFF: Press the power Button and a tone will be heard.

Activate Siri on iOS device

Press and hold the PLAY button for 2-3 seconds (works only in Bluetooth mode).

Pairing and connecting 2 x MiiBLASTER XL speakers with TWS

TWS only works when connecting two MiiBLASTER XLs by MIIEGO® together.

1. Turn on both speakers (Bluetooth mode). Make sure they are unconnected.
2. Press and hold button 6 on one speaker for 4 seconds. The product emits a tone to indicate entering TWS-pairing mode.
3. Activate Bluetooth on your audio source and connect with the product. The product emits three tones and button 6 lights up to indicate successful TWS-pairing.

To prevent possible hearing damage, do not listen at high volume levels for long periods.

Model No.: MiiBLASTER XL Designed in Denmark. Produced in China.
MIIEGO A/S
Lejrvejen 4
6330 Padborg
Denmark
tel: +45 70 277 887
e-mail: [email protected]

References

• MIIEGO - Active Lifestyle Audio

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>