MIIEGO AXTIVE M1 Wireless Speaker User Guide
- June 5, 2024
- MIIEGO
Table of Contents
MIIEGO AXTIVE M1 Wireless Speaker
OVERVIEW
- Reflective hanger
- – Volume Down / Previous Song Press once / Hold
- Play button: Play, pause, answer call, TWS.
- + Volume Up / Next Song Press once / Hold
- Power button: Power on/off,
- Reset.
- Mode button: Switch between Bluetooth and AUX
- LED indicator for charging
- Charging port
- AUX IN port
- LED Bluetooth indicator
- Microphone
SPECIFICATIONS
Bluetooth v5.0 – Wireless transmission range up to 10-15 m. without obstacles. Rechargeable 800 mAh Li-ion battery. Full charging time: around 2.5 hours. IPX7. BT frequency range: 2402-2480MHz. Freq. Response: 90Hz-20 KHz. Charging input power: 5V DC/1A. RMS audio output: 5W. Impedance: 4Ω.
CARE, MAINTENANCE, SAFETY
Any modification of the product may have consequences for safety, warranty and proper functioning. Keep out of reach for children and animals. Product storage and working temperature: from -10 celsius degrees to +40. Do not expose the product to direct sunlight, heat or naked flames as it may cause damage or explosion. Do not use the product if a part is damaged or defective. Replace a damaged or defective device immediately. Disconnect the product from the electrical outlet and other equipment if problems occur. Do not charge when the product is wet. Do not leave a battery on prolonged charge when not in use. Do not dismantle, open or shred batteries. Do not drop the product and avoid bumping. This product may only be serviced by a qualified technician for maintenance to reduce the risk of electric shock etc.
Pairing your AXTIVE M1 Bluetooth speaker
- Make sure the speaker is charged and turned OFF.
- Press and hold the button for 3 seconds until the indicator light flashes WHITE (pairing mode).
- Activate Bluetooth on your phone or other device and search for new Bluetooth device and select: MIIEGO AXTIVE M1.
When AXTIVE M1 is connected the WHITE LED light is constantly on. The speaker will remember your phone/device and automatically reconnect the next time you turn it on. An unpaired speaker will automatically turn off after 6 minutes. Charging the AXTIVE M1 speaker Use a 5V/1A USB adapter for charging. During charging the red right is on. When fully charged the red light is off. Full charging time is around 2.5 hours with 1A.
Next time charging
When you hear a warning tone every 180 seconds, the battery status is low and
needs charging.
Turning Your AXTIVE M1 On and Off
ON: Press the Button for 3 seconds until a tone is heard. OFF: Press the
Button until a tone is heard. Activate Siri on an iOS-device: Double press the
PLAY button (works only in Bluetooth mode). Play music from AUX mode Insert
AUX audio cable on the bottom of the speaker. (in AUX mode switching songs on
+/- buttons is unavailable)
Pairing and connecting 2 x AXTIVE M1 speakers with TWS
TWS only works when connecting two AXTIVE M1s by MIIEGO® together. There needs
to be free distance between them.
- Turn on both speakers (Bluetooth mode). Make sure they are unconnected. 2: Press and hold the PLAY button on one speaker for 2 seconds. The product emits a tone to indicate entering TWS-pairing mode.
- The product then emits three tones and the LED indicator light (10) will be constantly on. This is then the slave speaker. LED indicator light on master speaker will flash to indicate successful TWS-pairing.
- Activate Bluetooth on your phone/device and connect with the master speaker.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>