MIIEGO Simple Go Wireless Headphones User Guide
- June 5, 2024
- MIIEGO
Table of Contents
MIIEGO Simple Go Wireless Headphones
- Volume Down : Previous Song Press once / Hold
- Volume Up: Next Song Press once / Hold
- M-button: Turn headphones on/off. Play/pause. Answer call, end/reject call.
- Charging port
- Built-in Microphone
- LED indicator
- Line in AUX 3.5mm jack
SPECIFICATIONS
- Bluetooth v5.0.
- Rechargeable 300 mA/h Li-ion battery. Full charging time: around 2-3 hours.
- Frequency range: 2.402-2.480GHz. Freq. Response: 20Hz-20KHz.
CARE, MAINTENANCE, SAFETY
WARNING : Do not use while driving or where vehicular traffic is present,
or in any other activity where failure to hear your surroundings could be
dangerous.Use of these headphones at excessive volumes may cause permanent
hearing damage. Always turn the volume down before use. Keep out of reach for
children
and animals. Avoid direct sunlight. Product storage and working temperature:
from -5 degrees to +40 degrees. Do not dispose the battery in fire, as it may
cause explosion. Any changes or modifications to device will void the user’s
authority to operate the device. Do not open the product.
Pairing Your SIMPL GO Bluetooth Headphones:
- Make sure your SIMPL GOs are charged and turned OFF.
- Press and hold the M-button on the headphones for 5 seconds until the indicator light flashes Red and Blue alternatively (pairing mode).
- Activate Bluetooth on your phone or other device and search for Bluetooth devices and select SIMPL GO by MIIEGO.
Charging Your MIIEGO® Headphones:
When the Red light is on, the headphones are charging. When the Red light is
off, the headphones are fully charged.Full charging time is around 2-3 hours.
Next time charging: When the LED indicator light is flashing every 5
seconds, the battery status is low and needs charging.You will then also hear
a battery warning tone every 180 seconds.
Turning Your MIIEGO® Headphones On and Off:
- ON: Press the M-Button for 3 seconds until the indicator light flashes Blue 3 times.
- OFF: Press the M-Button until the indicator light flashes Red 2 times.
Activate Siri on iOS-device: Double press Volume-down button (work only
In STANDBY mode).
Perform Soft Reset: During charging, press and hold M-button and Volume-
up button for 5 seconds.
WARNING:
Only listen to music in a moderate volume and in moderate periods of time. Excessive exposure to high sound levels can lead to noise-induced hearing loss.
This device contains a lithium accumulator.Improper use can cause overheating and fire.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>