iHip WLGJAMBAR Wireless Speaker Instruction Manual

June 6, 2024
iHip

iHip FDJAMBAR Bluetooth Wireless Speaker - logo

INSTRUCTION MANUAL
PLEASE READ ALL INSTRUCTIONS CAREFULLY & RETAIN THEM FOR FUTURE USE

Getting Started

Remove the unit from the box.
Remove any packaging from the product.
Please retain all packaging until you have checked and counted all the parts and the contents against the parts list.

Package Contents

JAMBAR Speaker
2 In 1 USB Charging & 3.5mm Auxiliary Cable
Instruction manual

IMPORTANT SAFETY INFORMATION

  1. Read all instructions before using this product.
  2. Do not leave this product unattended while connected to the power
  3. Do not immerse in water or any other liquids.
  4. Do not use if the unit has been dropped or damaged in any way.
  5. Repairs to electrical equipment should only be performed by qualified personnel. Improper repairs may place users at serious risk
  6. Place unit on sound, even surface, free of vibrations and away from sources of heat.
  7. Do not use with wet hands.
  8. Do not put objects into openings.
  9. Keep free of dust, lint, hair, etc.
  10. Do not use this unit for anything other than its intended use.
  11. Keep this product out of reach of children.
  12. This product is not a toy.
  13. Do not play music at excessive levels especially near children, as damage to the hearing may occur.

DESCRIPTION OF PARTS

1 Skip Backward/Decrease Volume 6 TF Card Slot
2 Skip Forward/Increase Volume 7 USB Charging Port
3 Mode Button 8 USB Slot
4 Play & Pause
5 ON/OFF Switch

INSTRUCTIONS FOR USE

Charging the speaker
For best results, fully charge the speaker before use.

  1. Connect the USB cord (included) to the charging port of the speaker and insert the other end into a port on your computer or similar suitable power source.
  2. The Red LED turns on, indicating that the battery is being charged. Once it is fully charged, the Red LED will turn off. It takes about 1.5 hours to charge the speaker fully.

Turn On/Off the Speaker

  1. To Turn “ON’; slide the”ON/OFF” switch to the ON position.
  2. To Turn “OFF: slide the”ON/OFF” switch to the OFF position.

Pairing your device with Bluetooth Speaker
Your Bluetooth Speaker can wirelessly stream audio from any Bluetooth-enabled device within 30 Feet. Simply follow the below steps.

  1. Turn ON the speaker.

  2. You would hear the indication tone.
    The speaker is now in pairing mode.

  3. Turn on the Bluetooth on your Mobile Phone Tablet or Computer.

  4. It will search for various devices.

  5. The pairing name of our Bluetooth Speaker is”JAMBAR” ; pair it with this device.

  6. If required, enter the password’0000’to confirm to finalize the pairing.

  7. Once paired successfully, you would hear an indication tone.

  8. If you fail to pair it with in the time frame or you want to pair it with a new device please follow the steps outlined above.

Select your favorite song on the Bluetooth device and music would now stream through Bluetooth speaker.
( Note: Speaker will automatically pair with previously paired devices)

Talking using the Bluetooth Speaker
Please ensure that your cell phone is paired with the Bluetooth Speaker to use the below functions.

Function Operation Button
Answer Incoming Call Incoming Call Press the iHip button(4) once to

answer an incoming call.
End Call| Incoming Call| After your phone conversation, short press the iHip button(4)
Volume Increase| During a call| Long press on the + button will increase the volume
Volume Decrease| During a call| Long press on the button will decrease the volume
Redial last number| Standby mode and connected to a device| Short press the iHip button(4) twice

Listening to Music Wirelessly
Please ensure that your device (iPhone, Tablet, or Other Smart Phone) is paired with the Bluetooth Speaker to stream music wirelessly. Once it is paired, play music from your device.

II Operation Button
Increase Volume Playing music A long press on the + button(2) once will

increase the volume
Decrease Volume| Playing music| A long press on the – button(1) once will decrease the volume
Pause| Playing music| Short press the iHip button(4) once to pause the music
Play| Pause| Short press iHip button(4) once resume the music
Previous track| Playing music| Short press the – button(1) to the previous track
Next track| Playing music| Short press the + button(2) to the next track

Aux function of the Speaker (to play music from non-Bluetooth devices)

  1. Turn on the speaker, and short press the M button (3) to switch into AUX input mode.
  2. Plug the 2 in 1 cable (included) which the side is charging cord into the charging port (7) of the speaker. And, connect the other end of the cable (3.5mm auxiliary cord) to the audio device (such as MP3 Players/computer/tablet, etc.).
  3. Select your favorite song at the source device.

Note: Once the AUX cable is connected to the Speaker, music through Bluetooth will be stopped.

Listening to Music using USB/TF Card Slot

  1. Turn on the speaker.
  2. Insert TF card or USB flash drive into the TF Card Slot or USB Slot. Music would be automatically streamed.
  3. Short press + or – button to move forward or backward on your
  4. Short press the iHip button to Play or Pause a track.

Note: While using Bluetooth, if you insert TF Card or USB Flash drive, the speaker would disconnect the Bluetooth connection and switch toTF card or USB card function. You can short press the Mode button each time until it goes back to Bluetooth mode.
TF Card/USB Flash Drive not included.

FM Radio

  1. Turn ON the Speaker.
  2. Insert the charging cable into the Micro port, leave the other end of the cord open. The charging cable serves as FM Antenna.
  3. Short press the Mode buttons each time until FM mode is selected.
  4. Short press the iHip button (4) and the device would automatically search and store all the FM Radio stations.
  5. Short press + or – button to change the FM Radio stations.
  6. When the unit is not in use, turn OFF the device to save the battery power.

Do’s and Don’ts
Do not play music at excessive levels as damage to hearing and/or equipment may result.
Do not use in wet or in damp surroundings.

Specification

Driver Diameter: 40mm
Impedance: 40
Battery: 350 mAh & 3.7 Volts
Playtime: 2hrs
Charging Time: 1.5hrs
Bluetooth Range: 10m
Frequency Response: 20HZ – 20K Hz

( Note: Battery life & charging time may vary based on usage & types of devices used.)

Troubleshooting

Problem Possible Cause Solution
Low sound level Source (Tablet Mobile Phone, Laptop, etc.) volume too

low.
Battery dead| Adjust source volume. Charge Battery.
Sound distorted| Battery nearly dead| Charge Battery.
No sound at all.| Source (Tablet Mobile Phone, Laptop.) turned off. Speaker turned off.
Volume turned down the source.
Media paused on the source.| Turn the source on.
Turn the speaker on. Adjust volume source. Play media from the source.
---|---|---

Care and Maintenance

Clean the unit with a soft, damp cloth. Never use chemicals or hard abrasives.
Keep this unit away from wet or damp surroundings.
The crossed-out wheelie bin symbol on this item indicates that this product needs to be disposed of in an environmentally friendly way when it becomes of no further use or has worn out. Contact your local authorities for details of where to take the item for recycling.

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

The device has been evaluated to meet general RF exposure requirements.

© 2021 Zeikos, Inc. iHip is a trademark of Zeikos, Inc., Registered in the U.S. and other countries. The illustrated product and specifications may differ slightly from that supplied. All other trademarks and trade names are those of their respective owners. The United States and international patent pending. All Rights For ages 12+up. This is not a toy. For warranty information please visit www.ihip.com. Designed by iHip, Manufactured in China.

The Bluetooth° word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., and any use of such marks by “Zeikos” is under license. Other trademarks and trade names are those of their respective owners.

Limited 1 Year Warranty.
Customer service: 1-800-500-4434
To activate your product warranty go to our website www.ihip.com & register this product.

This equipment should be installed and operated with a minimum distance of 20cm between the radiator& your body.

iHip FDJAMBAR Bluetooth Wireless Speaker - logo

19 Progress St
Edison, NJ 08820
www.iHip.com

| #iHip| | Find us on Facebook.
Keyword: iHip: Portable
Entertainment
---|---|---|---

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals