Xing Da Electronics AU007 Wireless Speaker User Guide

Xing Da Electronics AU007 Wireless Speaker

All product names. trademarks, and registered trademarks are property of their respective owners. All company, product, and service names used in this document are for identification purposes only. Use of these names. trademarks, and brands does not imply endorsement
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc .• used under license

FCC Information

This device complies with Part 15 of the FCC Rules.
Caution: Any changes or modifications not expressly approved could void the user’s authority to operate the equipment.
Note: This equipment hos been tested ond found to comply with the limits for o Closs B digitol device. pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and. if not installed and used in accordance with the instructions. may cause harmful interference to radio communications. However. there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception. which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference
2. this device must accept any interference received, including interference that may cause undesired operation.

Radiation Eposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

LITHIUM POLYMER BATTERY WARNINGS

This device contains a non-removable Lithium-Polymer battery. The battery must be recycled or disposed of properly. Contact your local waste management office for information on battery recycling or disposal.

Rating Label Definitions

Direct current symbol.
This symbol signifies that this is a wireless device powered by Bluetooth® technology. The Bluetocth® word mark and logos are registered trademarks owned by Bluetooth SIG. Inc .. used under license.
This symbol signifies that the product must not be discarded as household waste. and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment.
This symbol signifies anc declares that this equipment complies with battery charging which complies with California CEC and energy efficiency.

Before You Begin …
READ THIS MANUAL CAREFULLY AND SAVE FOR FUTURE REFERENCE
To ensure safe and proper use. read all safety information before using the device. Only use with manufacturer-approved batteries. chargers. accessories. and supplies.

• THIS DEVICE IS NOT A TOY. do NOT allow children or pets to use or play with this device.
• Do not disassemble, modify, or repair the device.
• Do not expose the device to extreme temperatures (heat or cold). open flames. wet. or humid conditions.
• Do not subme.rge in water. See the Using in Wet Conditions section before using in wet conditions.
• Low power may cause poor Bluetooth connection or sound distortion.
• Do not overcharge battery.
• Check device, accessories and cables regularly for damage. Do NOT use if damaged, contact manufacturer.
• Do not allow the USB port or the connectors of the supplied USB cable to be exposed to dust. or water. or come into contact with any conductive materials such as liquids, metallic powders, etc.
• This device contains a built-in battery and should not be disposed of with regular household waste. Please consult the local authorities on the correct way to dispose of this device.

Questions & Customer Support
For any issues concerning this product, please visit our website at customersupport123.com.

In the Box

• BSSK9027 -Wireless Speaker (x1)
• USB Charging Cable (x1)
• Instruction Manual (xl)

Location of Controls

1. Carrying Loop

2. Microphone

3. [ + J Button:
   Press: Skip to next track Press + hold: Increase volume

4. [ – J Button:
   Press: Skip to previous track Press + hold: Decrease volume

5. [ 0 J Button:
   Press: Play/pause. answer/end call 2x Press: Redial last outgoing number 3x Press: Disconnect two speakers Press + hold: Reject incoming call Press+ hold: Power ON/OFF

6. Protective Rubber Seal

7. USB Type-C Charging Port

8. LED Light

Charging the Speaker

Note: II you have been using the speaker in wet conditions. you must dry it off completely before unsealing the water-resistant cover to charge.
Undo the seal covering the charging port on the speaker. Plug the small connector of the included charging cable into the charging port. Plug the large connector into a USB power source such as a 5V/1A USB power adapter.
The LED light on the top of the speaker will light up RED while charging and turn OFF when fully charged.

On lower power. a tone will be heard indicating that the speaker needs to be recharged.

Using in Wet Conditions

The BSSK9027 speaker has an IPX6 rating. This means it can withstand water splashes from any direction, but should not be submerged in water under any circumstances.
Be sure to completely seal the water-resistant cover over the charging port before taking the speaker in wet conditions, and dry the speaker off completely before opening the seal to charge.

Powering ON/OFF

• Press and hold the [ 0 I button on the top of the speaker for 3 seconds to power ON. A tone will be heard and the speaker will automatically re-pair to a previously-paired device in range. If no device is found after 3 seconds, the speaker will enter Bluetooth pairing mode.
• Press and hold the [ 0 J button for 3 seconds to power OFF.

TWS Pairing Two Speakers

If you have two BSSK9027 speakers, you can make a True Wireless (TWS) pairing between them by following the below steps.

1. Place the two speakers near each other, and power both ON at the same time.
2. The speakers should pair to each other automatically. The LED indicator on both speaker will flash six color.
3. Follow the Bluetooth Pairing instructions below to connect your device to the speaker pair.

• Note: 3x press the [ 0 J button on either speaker to disconnect two speakers when the speakers are not paired to your device.
  Note: If you have previously paired your device to one of the speakers, you may need to turn its Bluetooth off while you pair the speakers to each other.

Bluetooth Pairing

1. Power the speaker ON. A tone will be heard and the LED indicator will flash SIX COLOR.
2. Set your mobile device to search “or Bluetooth devices. When it appears. select BSSK9027 from the list of found devices.
3. After a successful pairing, a tone will be heard and the LED indicator will Color Changing of Six Color.

Using the LED Lights

Press”+” and .. _ .. at the same time to switch in between three RGB flash mode

1. Music Sync Mode
   When µlaying music, the LED ight will flash according the music. And will color changing when pause the music.

2. Color Changing Mode
   Press “+”and”-” at the same time, the LED light will turn the second mode; the LED light will keep color changing of six colors.

3. Light Off Mode
   Press “+” and “-” at the same time again, the LED light will turn OFF.
   Noted: Only can change the mode when the music is playing.

Adjusting Volume & Playback

When paired to a Bluetooth device, volume and playback can be adjusted with your paired device. or with the speaker controls listed below.

• Press the [ – ] and I + ] buttons to skip tracks.
• Press and hold the [ – land [ + l buttons to adjust volume.
• Press the I O J button to pause and resume playback.

Phone Functions

When paired to a Bluetooth device. you can control phone functions with your paired device, or with the speaker controls listed below.

• Press the [ 0 l button to answer an incoming phone call.
• Press the [ 0 J button to end a phone call.
• Press and hold the [ 0 J button to reject an incoming call and sent straight to voicemail.
• 2x press the [ 0 J button to redial the last outgoing number.

Storage & Maintenance

The speaker should be cleaned by wiping the outside surface with a damp cloth only.
The speaker is best stored in an airtight box or bag (not included) away from sources of dust, wind, moisture and sunlight. For best results. fully charge the speaker once a month, even if it is not being used.

Warranty Information

90-Day Limited Warranty
Territory: United States/Canada

LIMITED WARRANTY TO ORIGINAL CONSUMER
This product as supplied and distribJted new by an authorized retailer is warranted by Southern
Telecom, Inc. to the original consumer purhaser against defects in materials and workman­ship (“Warranty”) as follows:

To obtain warranty service:

• Visit our customer support portal: www.customersupport123.com
• Select the brand and model of your device
• Select “Service Request” and fill out the form to begin your inquiry
• Exchanges require dated proof of purchase from an authorized retailer

Your product will be repaired or replaced, at our option, for the same or similar model of equal value if examination by the service center determines this product is defective. Products received damaged as a result of shipping will require you to file a claim with the carrier.
Warranty service not provided
This warranty does not cover damage resulting from accident, misuse. abuse, improper installation or operation. lack of reasonable care. unauthorized modification including software modifications such as the installation of custom firmware. This warranty is voided in the event any unauthorized person opens. alters or repairs this product. All products being returned to the authorized service center for repair must be suitably packaged.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>