Xing Da Electronics XY-AU048 Wireless Speaker User Manual
- June 5, 2024
- Xing Da Electronics
Table of Contents
Xing Da Electronics
XY-AU048
Wireless Speaker
Functions:
- Power Button/Play/Pause,Answer/End call.
- Vol-/Previous Track
- Vol +/Next Track
- Type-C charging port
- Charging LED Indicator
- Bluetooth LED indicator
Tech Specifications:
Pairing name: Whammo 2.0 Speaker
Battery capacity: 600 mAh
Bluetooth version: 5.3
Charging time: about 3 hours
Playing time in max volume: no less than 3 hours.
How to use the speaker:
1. Bluetooth Setup:
- Press and hold the power button to turn ON the speaker, the LED indicator will flash BLUE when in pairing mode.
- Turn on the Bluetooth function on your mobile device, Select the “ Whammo 2.0 Speaker” pairing name.
- LED will turn solid BLUE if successfully paired, the LED will flash in BLUE slowly when playing.
- Speaker will automatically pair if the mobile device has been paired before.
- If disconnect Bluetooth after 5 mins, the speaker Bluetooth will auto shut off.
2. Playing Music:
When connected to a Bluetooth device, playback can be controlled with your
connected device, or with the speaker controls listed below.
- Short press the “ ◁ ” button to pause music. A second short press will resume playing music again.
- Long press the “-” button, and the speaker will play the previous track. Short press to reduce speaker volume.
- Long press the “+” button, and the speaker will play the next track. Short press to increase speaker volume.
3. Call Function:
Phone functions can be controlled through the speaker when Bluetooth-paired to
a phone with the commands below.
- Short press the “◁ ” button to answer an incoming call, and press again to end the call.
- Long press the “◁ ” button to reject the call.
4. Charging the Speaker
- Plug the small connector of the included charging cable into the charging port on the side of the speaker. Plug the large connector into a USB power source, such as a 5V/1A USB wall adapter (not included).
- The charging LED indicator will turn RED while charging and turn OFF when fully charged. When the speaker is low on power, a tone will be heard indicating that it needs to be recharged.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be u sed in portable exposure conditions without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>