XING DA INTERNATIONAL ELECTRONICS LIMITED PR037 Wireless Charging Pad User Manual
- June 1, 2024
- XING DA INTERNATIONAL ELECTRONICS LIMITED
Table of Contents
XING DA INTERNATIONAL ELECTRONICS LIMITED PR037 Wireless Charging Pad
Function
- Wireless charging Pad
- LED indicator
- Type-C USB input Port
What include
1 x Wireless Charging Pad
1 x USB-C to Type-C Charging Cable
1 x Instruction Manual
Specs
Input : 5V/2A; 9V/2A;
Wireless Output : 5W/7.5W/10W/15W
Instructions
- Connect the provided Type-C USB to USB-C cable to the Type-C USB input port (3), then connect the USB end of the cable to a power source ( not include) which can support 5V/2A or 9V/2A.
- LED indicator(3) will flash BLUE&RED alternately 3 times, then glow RED to indicate the wireless charger is in standby mode and ready to begin charging.
- Place the wireless charging supported mobile phone/device upright on the wireless charging surface(1) ,LED will glow BLUE when device is charging.
- Phone will begin to charge automatically.
- Once fully charged remove the device
Note: When wireless charging, if the Led indicator flash RED the device is either NOT a wireless charging device or there is an object between the the device and charging surface interfering with the charging process.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum 20cm distance between the radiator and your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>