anslut 019880 Ceiling Light Fixture with Motion Sensor Instruction Manual
- June 4, 2024
- anslut
Table of Contents
Item no. 019880
CEILING LIGHT FIXTURE WITH MOTION SENSOR
OPERATING INSTRUCTIONS
Important! Read the user instructions carefully before use. Save them for future reference. (Translation of the original instructions)
SAFETY INSTRUCTIONS
- The product must only be used as It Is intended to be used and in accordance with these instructions in order to comply with the relevant safety standards. The electrical installation must comply with the applicable national regulations.
- Dangerous voltage runs through the wires in the product.
- Disconnect the power supply before installation and make sure it cannot be reconnected by mistake.
- Failure to follow all the instructions and Safety instructions can result in a risk of fatal or serious personal injury.
- Unpack and check the product and all the parts for transport damage. Do not install or use the product if it is damaged. Take the product to an authorised service centre to be checked, repaired or adjusted.
- Do not connect the power supply to the product while still in the pack — risk of material damage.
- Switch off the power supply before working on the product.
- The product does not contain any parts that can be repaired by the user.
- Parts of the product get hot when in use
—risk of burn injury. Do not touch the product until it has cooled.
ELECTRICAL SAFETY!
New installations and extensions to existing systems should always be carried out by an authorised electrician. If you have the necessary experience and knowledge (otherwise contact an electrician), you can replace power switches and wall sockets, fit plugs, extension cords and light sockets. Incorrect installation can result in fatal injury and the risk of fire.
SYMBOLS
| Read the instructions.
---|---
| Approved in accordance with the relevant directives.
| Recycle discarded product in accordance with local regulations.
| Safety class II
TECHNICAL DATA
| Rated voltage | 230 V — 50 Hz |
|---|---|
| Output | 24 W |
| Safety class | II |
| Protection rating | IP20 |
| Colour rendering index | 80 |
| Colour temperature | 3000/4000 / 6000 K |
| Energy class | F |
| Luminous flux | 2500 Im |
| Life span | 30000 h |
| Size | 033xh 15 cm |
| Weight | 1 kg |
INSTALLATION
WARNING!
Parts of the product get hot when in use — risk of burn injury. Do not
touch the product until it has cooled.
- Fit the bracket to the ceiling. The product should be installed no more than seven metres above the floor. FIG. 1
- Connect the live wire and neutral wire to the corresponding terminals on the product. FIG. 2
- Set the required colour temperature: see the table Optional colour temperature. FIG. 3
- Align the lugs on the lamp to the slots on the ceiling bracket and press the lamp in place over the bracket. FIG. 4
- Turn the lamp to lock it in place on the bracket. FIG. 5
OPTIONAL COLOUR TEMPERATURE
The product has three colour temperature settings, which are set with a
selector.
Set the required colour temperature before installation.
| Mode | Colour temperature |
|---|---|
| CW | 6000 K |
| NW | 4500 K |
| WW | 3000 K |
USE
MOTION DETECTION
- The product switches off automatically after three seconds if there is no activity.
- The product is controlled by a motion detector and reacts to persons at a distance of about five metres, assuming that it is installed no more than seven metres above the ground.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>