crivit D7A8 LED Bike Light Set User Guide

: June 6, 2024
: crivit

Table of Contents

Introduction
Safety notes
- Rechargeable battery safety notes
Installation
- Installing the headlight (see Fig. A)
- Installing the tail light (see Fig. B)
Operation
Documents / Resources

LED BIKE LIGHT SET
Quick start guide

LED Bike Light Set

Introduction

This quick start guide is a fixed part of the operating instructions. Keep both this and the operating instructions in a safe place. When passing this product on to third parties, please be sure to include all documentation. Read the operating instructions before use, and pay particular attention to the safety instructions included in the operating instructions. Scan the QR code, or download the complete operating instructions at www.lidl- service.com.

Safety notes

WARNING! DANGER TO LIFE AND RISK OF AC-CIDENT FOR INFANTS AND CHILDREN! Never leave children unsupervised with the packing material due to the suffocation hazard posed by swallowing parts thereof. Children frequently underestimate the dangers.
Always keep the product out of the reach of children. This product is not a toy!
This product may be used by children aged 8 years and up, as well as by persons with reduced physical, sensory or mental capacities or lacking experience and knowledge when supervised or instructed in safe product use and they understand the associated risks. Do not allow children to play with the product. Cleaning and user maintenance must not be performed by children without supervision. Please note, damages caused by incorrect handling, non-compliance with the instructions for use or interference with the device by unauthorised individuals are excluded from the warranty.
Never take the product apart. Improper repairs may result n considerable danger to the user. Always have repairs performed by a professional. The LED lights cannot be replaced.

WARNING! DANGER TO LIFE AND RISK OF ACCIDENTS! Using an incorrect charger can result in headlight 1 and tail light 9 damage, overheating and even explosion. This will void the warranty.

Rechargeable battery safety notes

CAUTION! DANGER OF EXPLOSION! Keep rechargeable batteries away from children, do not throw rechargeable batteries into fire, do not short-circuit and do not take apart.
Failure to observe this may discharge the rechargeable battery beyond their end voltage. This poses a risk of leaking. Avoid contact with the skin, eyes and mucous membranes if fluid has leaked from the rechargeable batteries. In the event of contact with battery acid, thoroughly flush the affected area with clean water and seek immediate medical attention. Note: If the red LED on the battery monitor 2 on the headlight 1 or the blue LED on the battery monitor 11 on the tail light 9 lights up, recharge the batteries promptly.

Installation

Installing the headlight (see Fig. A)

Attach the headlight 1 as shown in Fig. A.

Installing the tail light (see Fig. B)

Attach the tail light 9 as shown in Fig. B.
ATTENTION! The tail light must be installed and adjusted so the reference axis is parallel to the median longitudinal plane of the bicycle and parallel to the road.

Operation

Switching on/off

The headlight 1 has three brightness settings.

On/Off switch 4

press once| Auto mode: The headlight 1 is equipped with a sensor 5 which automatically adjusts the brightness of the headlight 1 to the surrounding brightness. When the sensor is active 5 (auto-mode), the sensor control light 3 flashes green.
---|---
press twice| Power mode (70 Lux) for riding in unlit areas
press three times| Standard mode (30 Lux) for riding in lit areas
press four times| Eco mode (15 Lux) for riding in well-lit areas
press five times| Power off

Battery status:	Operating mode of the battery monitor
100 % – 75 %	4 green LEDs light up
75 % – 50 %	3 green LEDs light up
50 % – 25 %	2 green LEDs light up
25 % – 10 %	1 green LED lights up
10 % – 0 %	1 red LED flashes