SERVER EZT EZ-Topper 48 oz. 2-Pouch Twin Topping Warmer Instruction Manual
- June 6, 2024
- SERVER
Table of Contents
SERVER EZT EZ-Topper 48 oz. 2-Pouch Twin Topping Warmer Instruction Manual
PARTS
KNOBS ON CUSTOM UNITS MAY VARY
SAFETY
UNIT SETUP
WASH ALL PARTS PROPERLY BEFORE EVERY USE. See page 6.
SEE SEPARATE PUMP MANUAL FOR PUMP SETUP.
UNIT TAKE-DOWN
CLEANING
SEE SEPARATE PUMP MANUAL FOR PUMP INSTRUCTIONS.
WARNING- ELECTRICAL SHOCK COULD OCCUR
- Electrical components of unit could be damaged from water exposure or any liquid.
- Never immerse unit into water or any liquid.
- Never use any water jet or pressure sprayer on unit.
- Ensure unit is “OFF” and unplugged.
CAUTION- HOT
CLEAN EXTERNAL SURFACES
- Wipe daily with a clean damp cloth.
- Dry with a clean soft cloth.
- Glass and surface cleaners approved for use
CARE OF STAINLESS STEEL
This warmer and accessories are constructed of stainless steel– one of the
best materials for food serving and storage.
If you notice corrosion beginning on any stainless steel surface, you may need
to change the cleansing agent, sanitizing agent, or the cleaning procedures
you are using.
- A mildly abrasive nylon or brass brush may be used to remove any stubborn food or mineral deposits on interior surfaces of unit.
- Fully rinsing and drying all parts can help prevent corrosion. Elements and minerals in tap water can accumulate on stainless steel parts and create corrosion.
- Do not use abrasive, caustic or ammonia based cleansers.
- Do not use products containing acids, alkaline, chlorine, or salt. These agents can corrode stainless steel.
- Do not use metal scrapers or cleaning pads that could scratch surfaces.
WIRING
UNITS 85713, 85714, 85843 | 120V | USA
- Cord Assembly
- Bushing/Strain Relief
- Snap-In Rocker Switch
- 6″ Wire Assembly, Black
- Thermostat
- Heating Element
- 6″ Wire Assembly, Green
- 18″ Wire Assembly, Green
TROUBLESHOOTING
UNIT DOES NOT HEAT?
- Ensure cord is securely plugged in.
- Ensure unit is on.
- Ensure thermostat knob is set correctly.
- Ensure power is available from source.
- Do not allow any of the electrical components to get wet. Moisture may cause the unit to trip breaker or GCFI. If moisture is suspected, discontinue use. Allow unit to fully air dry.
POUCH DOES NOT EVACUATE ALL PRODUCT?
- Ensure that the pouch is properly connected with pump.
SERVER PRODUCTS
This Server product is backed by a two-year limited warranty against defects in materials and workmanship. See Server-Products.com for details.
GENERAL SERVICE
Before sending an item to Server Products, contact Customer Care to request a
Return Authorization Number. The RA Number ensures proper processing and a
prompt turnaround. Repaired units are typically shipped out within 48 hours of
receipt.
Merchandise returned for credit will incur a 20% restocking charge, must be
less than 90 days old, and in unused (new) condition. Electrical parts
(thermostats, heating elements, etc.) are not returnable.
Servicing Cord: Specific tools are required for safe and proper power supply
cord removal and installation. Repairs should be done by an OEM representative
or qualified technician using a cord meeting code H05 RN-F requirements.
NEED HELP?
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>