F69 Earbuds User Manual
- June 6, 2024
- Earbuds
Table of Contents
F69 Earbuds
Product Function introduction
- Earphone charging contact
- ENC Microphones
- Multi-function touchpoint
- ENC Microphones
- Battery indicator
- Type-c Charging port
Packaging accessories
- Charging compartment
- Earphone
- Charging Cable
- Certificate
- User manual
Instructions for headset touch operation
Earphone connection instructions
A.Singles-ear mode: take out a earphone.
B.Binaural mode: first turn off the BT of the device and take out the headset.
Touch (L) the left ear twice and wait for 3-5 seconds, the pairing is
successful with the slow blinking white light on both ears (for details,
please refer to the index below
a . Take out the earphones
b . Touch twice and wait for 3-5 seconds to pair successfully
c. The second use, charging lid is opened, the headset automatical boot,
automatic matching
Connect
A)Device connection: Open your phone or another device, search for “F69”, and
click Connect.
B)The left and right earphones can be connected separately.
Turn it off
- a.Put it in the charging case and close the lid
- b.Without work for 5 minutes, the earphones will shutdown
- c.Long press for about 5 seconds to turn on/off the earphones
Charging instructions
- When the battery is low, the sound prompts to charge.
- Headphone breathing light is always on when charging, and turns off when fully charged
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by the manufacturer could void your authority to operate this
equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The
device can be used
in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>