motorola EDGE-WC-BK Wireless Charging Case User Guide

: June 6, 2024
: Motorola

Table of Contents

Features:
Installation:
Push the rest of the phone into the case.
For direct charging:
Uninstallation:
Documents / Resources

Wireless Charging Case
User Guide
(EDGE-WC-BK)
(pp.0 1 -03)

Features:

Built in 10W Qi compatible receiver, 5V/1A, 9V/1.1A.
Wired USB-C input accepts 5V/3A, 9V/2A, QC3.0 & USB-PD 18W TurboPower pass-through wired charging.

Installation:

Attach your Motorola Edge
USB-C charge port to the
USB-C connector in the wireless charging case.
Align the bottom of the phone with the bottom of the case and push in.

Push the rest of the phone into the case.

For wireless charging:

Using a Qi wireless charging pad

Align the Motorola M-logo with the center of a wireless charging pad.
Place the back of the case onto a Qi wireless charging pad.
Ensure the wireless charging pad is charging.
Your device will begin to charge.

Note : Wireless charging pad and USB-C cable are sold separately.

For direct charging:

Connect your charger and USB-C cable to the USB-C port at the bottom of the phone case.
Note : Wall charger and USB-C cable are sold separately.

Uninstallation:

Keep the bottom of the phone and case connected, and slightly release the top of the Motorola edge phone for just enough to get out of the frame of the case top.
Keep the alignment of the bottom of the phone with the bottom of the case and pull the phone up from the case to disengage the USB-C charge port from the USB-C connector of the case.

FCC Notice to User
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. See 47 CFR Sec. 15.105(b). These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment of and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit diﬀerent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Industry Canada Notice to User, RSS-Gen Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause
undesired operation of the device. This device complies with ICES-003 requirements for Class B ITE (Information Technology Equipment). CAN ICES-3 (B)/NMB-3(B)
Recycling of Waste Electrical and Electronic Equipment (WEEE)
This symbol on the product or on its packaging indicates that this product must not be disposed of with your other household waste. Customers or end- users should contact their local equipment supplier or service center for information on the waste collection system in their country.
For warranty and more information:
motorolachargers.com/phonecases/

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Caution : Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirements.

Rev. 202010-01
Manufactured, distributed or sold by Salom Ltd., social licensee for this product. MOTOROLA and
Stylized M Logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC, and are
used under license. All other trademarks are the property of their respective owners.
© 2020 Motorola Mobility LLC. All rights reserved.
motorola.com

Printed in China

Documents / Resources

| motorola EDGE-WC-BK Wireless Charging Case [pdf] User Guide
MG101A-EDGE, MG101AEDGE, 2ARXU-MG101A-EDGE, 2ARXUMG101AEDGE, EDGE-WC-BK Wireless Charging Case, Wireless Charging Case
---|---