QCY-T5 True Wireless Earphones User Guide
- June 6, 2024
- QCY
Table of Contents
QCY-T5 True Wireless Earphones
Overview
How to Connect
First Time Pairing：
- Pick up both earbuds then re-insert them into the case. Once again, pick them up to activate them.
- On your cellphone, search for QCY-T5 and tap to connect.
*Once paired earbuds will auto power on upon picking up from the case. If earbuds fail to auto power on, please charge them and try again.
Switch Paired Device：
- Turn off the phone’s Bluetooth faculty and earbuds will auto disconnect and enter into pairing mode.
- On phones, search for QCY-T5 Pro and tap to connect.
*Multi-point connection is not available. Earbuds will auto-reconnect to the phone upon powering up again.
Factory Setting
(Try the following steps to fix connectivity issue) Set to factory：
- On a cellphone, search for QCY-T5, tap, and choose to ignore or cancel pairing.
- Pick up two earbuds, keep touching both bars for 8s or until LEDs glow red for 2s to power off.
- Keep touching both bars for 10s or until LEDs blink red and green 3 times then blink red to set earbuds to the factory.
Please refer to “First Time Pairing” to connect after the factory setting.
Manual Pairing (please refer the following steps in case two earbuds lose
connection)
Power off earbuds then keep touching panels for 5s or until LEDs blink red and
green. After then, double-touch panels and LEDs will blink red and green. Two
earbuds will then auto pair with each other when the LED on the master earbud
blinks red and green and the other one turns off.
How to Wear
- Rotate your earbud and pop it into your ear then shake your head to check wearing stability.
- Please adjust the mic towards your mouth to gain a better calling experience.
Three-way Calling & Switch
Double touch the bar to answer an incoming call. If another call is coming in sync, double touch again to put the first call on hold while activating the second one or keep touching the bar for 2s to ignore the second call. Keep touching the bar for 2s to switch between an active call and held call.
Mono Mode
- Power off earbud then keep touching the bar for 5s to enter pairing mode ( LED blinks red and green )
- On a cellphone, search for QCY-T5
- Tap to connect
Charging Earbud
Push the earbud into the case to charge. LED will glow solid red
when charging and turn to green for 1 minute once top-up.
Charging the Case
When the power is less than 30%, the two green lights of the charging box
flash; when the power is between 30% and 90%, the left light is always on the
green the right light is blinking; when the power is more than 90%, The two
green lights on the charging case are always on.
Functions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>