QCY-T6 TWS Bluetooth Earbuds Instruction Manual

QCY-T6 TWS Bluetooth Earbuds

Overview

Choose Your Eartips Please try medium eartips first as they fit most people.

How to Pair

First Time Pairing：

1. Pick up both earbuds，pop both earbuds into the case to activate them.
2. On cellphone, search for QCY-T6 and tap to connect.

Once paired earbuds will auto power on upon picking up from the case. If earbuds fail to auto power on, please charge them and try again.
Switch Paired Device：

1. Turn off phoneA’s Bluetooth faculty and earbuds will auto disconnect and enter into pairing mode.
2. On phoneB, search for QCY-T6 and tap to connect. *Multi-point connection is not available. Earbuds will auto reconnect to phoneB upon powering up again.

Factory Setting

(Try the following steps to fix connectivity issue) Set to factory.

1. On cellphone, search for QCY-T6, tap and choose ignore or cancel pairing.

2. Pick up two earbuds, keep touching both bars for 8s or until LEDs glow red for 2s to power off.

3. Keep touching both bars for 10s or until LEDs blink red and green 3 times then blink red to set earbuds to factory. *Please refer “First Time Pairing” to connect after factory setting.
   Manual Pairing (please refer the following steps in case two earbuds lose connection)

   • Power off earbuds then keep touching panels for 5s or until LEDs blink red and green. After then, double touch panels and LEDs will blink red and green. Two earbuds will then auto pair with each other when LED on master earbud blinks red and green and the other one turns off.

How to Wear

1. Rotate earbud and pop it into your ear then shake head to check wearing stability.
2. Please adjust mic towards your mouth to gain better calling experience.

Three-way Calling & Switch
Double touch the bar to answer incoming call. If another call is coming in sync, double touch again to put the first call on hold while activating the second one or keep touching the bar
for 2s to ignore the second call. Keep touching the bar for 2s to switch between active call and held call.

Mono Mode

1. Power off earbuds, hold Touch Panel on either earbud for 5s to enter pairing mode(LED blinks red and green )
2. On cellphone, search for QCY-T6 and tap to connect
3. Connected

Charging Earbud
Push earbud into the case to charge. LED will glow solid red when charging and turn to green for 1 minute once top up.
Charging the Case
LED on the case will glow solid red when battery level is under 60%; LED will turn green when battery level is between 60% and 95 and become solid blue when the battery level is over 95%.

Product Parameters

• Model: In1947 Pairing name: QCY-T6
• Bluetooth version: V5.0 Stand time: approx. 100hr Charging time: approx. 2hr Music time: approx. 6 hr Talking time: approx. 5.5hr
• Operation range: 10m(with no obstacle)
• Battery type: li-ion
• Battery capacity(earbud): 3.7V 60mAh
• Battery capacity(charging case): 3.7V 600mAh
• Input parameter(charging case): 5V 600mA
• Bluetooth profiles: HSP/HFP/A2DP/AVRCP

Function Introduction

Entering TWS Mode

| Power-off with no connectivity record| Keep touching the bar for 1s to power on and earbud will auto enter pairing mode| LED blinks red and green| TONE
Power off then keep touching the bar for 5s to enter pairing mode|

Double touch the bar to enter TWS mode

| LED blink red and green then right LED turns off|

TONE

Power-on

| Power-off| Keep touching the bar for 1s| LED glows green

for 1s

|

TONE

Charging| Pick up earbuds from the case| LED glows green for 1s

Power-off

|

Power-on

| Keep touching the bar for 8s(only two unpaired earbuds will be powered off together)| LED glows red for 2s|

TONE

Pop earbud into the case to power off| LED glows red
Answer/end call| Incoming call/calling| Double touch the bar|

\

| TONE
Ignore call| Incoming call| Keep touching the bar for 2s| | TONE
Voice assistant| Connected| Triple touch bar| | TONE
Incoming call| Connected to phone| Incoming call ring| | call ring
Music pause/play| Music playing| Double touch the bar to pause,double touch again to resume playing| | \
Skip track| Music playing| Keep touching right/left bar to skip track forward/backward| | \

Warranty Card

Warranty Period
12 months after you purchase this item.(or you may inquire your local shopper for more details.)

Free Service
Supposing any defects caused by quality issues o ccur within the warranty period, please take this warranty card and purchase receipts to your distributor for free exchange service.

Model Number:

Date of Purchasing:
User’s Name:
User’s Phone:
User’s Address:
Shop’s Name:
Shop’s Address:
Comments:

Free exchange service will not be accessed under following circumstances：

1. Damages caused unauthorized disassembl y.
2. Defects or physical damages caused by leaking or dropping off.
3. Damages by act of God.Supposing your item is within any damages or defects except the abovecircumstances, please return to us or your distributor for free repairing.

FCC Statement

This equipment has been tested and found to comply with the limits for a Cl ass B digital devic e, purs uant to P art 15 of the FCC R ules. T hese lim its are des igned to provid e re aso nabl e protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not ins tal led an d used in acc ordance with t he instructions, may cause harmful interference to radiocommunications. However, there is no gu arantee that interferenc e will not occ ur in a partic ular insta llation. If this equipment does caus e harmful interferenc e to radi o or tel evisio n rec eption , which can be dete rmined by turn ing the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:

•  Reorient or relocate the receiving antenna.

• Increa se the separat ion between the equipment and r eceiver. — Connect the equipment into an outlet on a circuit different
  from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complie s with part 15 of the FC C R ules . Operation is subject to the following two conditions:
(1) T his device m ay n ot ca use harmfu l interferenc e, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modificat ions n ot expres sly approv ed by the party responsible for com pliance coul d void the user’s authority to operate the equipment.

Hazardous substances and their contents in the item

This form is made by SJ/T 11364 regulation.
O: means that hazardous substance content in the homogeneous materials of this part is within the limits of (EU）2015/863 regulation .
X: means that hazardous substance content in ,at least,one certain homogeneous material of this part is beyond the limits of (EU）2015/863 regulation ,but there is no mature alternative in the industry at present, it still conforms to the EU ROHS Directive in the scope of exemption.

Notes: Pl ease ar range us ing tim e prope rly as your hear ing may be damaged b y using the device for a long time. Manu facturer: Dongguan Hele Ele ctronics C o., Ltd. Address: Daojiao Town, Dongguan Cit y, Guan gdong, China

Tips

1. Before using the headset, please read the manual carefully and keep it for future references.
2. The headset need to be fully charged prior to first-time use.
3. If the headset is left unused for over two weeks, please recharge it periodically.
4. Please use the chargers made by qualified manufacturer.
5. If the headset cannot be found by your phone, please check whether it is in pairing mode; if left unconnected for a long while, the headset will exit pairing mode, please re-enter the mode; if a procedure error of your phone occurs, reboot it; if a procedure error of the headsetoccurs, reboot or reset it.

Caveats

1. Never disassemble or modify your headset for any reasons to avoid any damages and danger.
2. Do not store the headset in extreme temperatures (under 0℃ or over 45℃).
3. Avoid using the indicator close to the eyes of children or animals.
4. Do not use this headset during a thunderstorm to avoid irregular function and increased risk of electricshock.
5. Do not use harsh chemicals or strong detergents to clean the headset.
6. Keep the headset dry.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>