Rabalux 4682 LED Smart Light Instructions
- June 3, 2024
- RABALUX
Table of Contents
Rabalux 4682 LED Smart Light
USAGE AND OPERATION INSTRUCTIONS FOR LIGHT FITTING!
For your safety, mount and put the light fitting into operation based on the instructions. Preserve these instructions. Identify the drawings on the product, on the data plate of the product, and in the instructions and take the warning texts into consideration. Before the mounting, putting into operation or repair of the light fitting the circuit in question must be relieved from voltage. It is appropriate to switch off the cutout securing the circuit in question or if you do not know which one is the cutout, then, to switch off the cutouts of the consumption meter. The light fitting must only be mounted and put into operation by a qualified electrician! The producer shall not be liable for incidental damages or accidents arising from non- standard connection and usage. Fixed light fitting. The product is only suitable for inside usage. The attached drawing should be used when the light fittings are mounted. Make sure that you do not damage any electric cables when you are mounting the light fitting. The colour codes of the wire are the following:
- black or brown (L) = phase conductor,
- blue (N) = neutral conductor
- In the case of a light fitting of shock protection class I: green-yellow =protecting conductor
Do not open the product! LED light sources are not replaceable. At the end of
the lifespan of the LED light source, the light fitting must be replaced. The
lamp is not designed for dimmer
Hereby, Rábalux Zrt. declares that the radio equipment type [4682] is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
www.rabalux.com
LED light -source, please do not stare at lights for long time!
- Lamp control using “iLink” app:
- Make sure that during the first synchronization GPS and the Internet are available on the device. Download the iLink app and install on the device.
- Open the iLink app and press ( ) menu button in upper left-hand corner. Select BT connect and press on “iLink app” to connect the device with the lamp.
- Once connected, the app is ready to use.
- The lamp can be controlled (switched on, off etc.) and music can be played using the “iLink” app.
- Play music only: Connect bluetooth on the device and search for the “iLink” device, then pair with the switched on lamp.
Function buttons on the remote control:
- Switch on – Switch off
- Colour change
- Volume increase / Brightness increase
- Play – pause / 3000K – 4000K – 6000K
- Previous song / Colour temperature decrease
- Next song / colour temperature increase
- Volume decrease / Brightness decrease
- Change function to music
- Change function to lamp
- 4000K
- Timer: 30 minutes
- Nightlight
Do not dispose of lamp in household waste
DISPOSAL
Ask you community or township for appropriate environmentally-friendly waste disposal. Our products comply with the relative European standards in each case
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>