rabalux Lava-Class-G-20210614-40 Desk Lamp User Manual
- June 3, 2024
- RABALUX
Table of Contents
Lava-Class-G-20210614-40 Desk Lamp
User Manual
Lava-Class-G-20210614-40 Desk Lamp
USAGE AND OPERATION INSTRUCTIONS FOR LIGHT FITTING!
For your safety, mount and put the light fitting into operation based on the
instructions. Preserve these instructions. Identify the drawings on the
product, on the data plate of the product, and in the instructions and take
the warning texts into consideration.
The product is only suitable for inside usage. Portable light fitting. The
light fitting can be connected to the network by the flat FLEXO plug that can
be found at the end of the electric wire.
Y: If the outer flexible cable is damaged, only the producer or a similarly
qualified electrician may exchange it.
This product contains a light source of energy efficiency class
Only a light source of maximum performance and of the type indicated in the
data plate and around the socket can be used for the product. In case of the
replacement of the bulbs first release the lamp fitting from tension (pull out
the mains plug), and wait until the bulb is cool.
Do not touch the with your hands the halogen bulbs, use a soft cloth or a
tissue to hold and put them in place.
The producer shall not be liable for incidental damages or accidents arising
from non-standard connection and usage.
Should you have any problems with putting into operation or operation, contact
a qualified electrician.
Disconnect the connector from the socket before cleaning.
Do not clean the light fitting with detergents or abrasive materials and avoid
contact of liquids with electrical parts.
Assembly:
- Place the base (A) onto a flat level
- Place the liquid containing glass (B) onto the base
- Place the cup (C) onto the top of the glass
- Plug in the connector, and switch on the lamp.
Operation:
The lamp operates properly at a room temperature of 21 to 26°C
Do not use it near a heater or air-conditioner and keep it away from strong
sunlight.
The apparatus must not be used as a child’s toy for children under 14 years
old.
The lamp needs 2 hours to warm up, and operates perfectly after 3 hours
following switching on.
The lamp is designed for a continuous operation of 12 hours at the specified
temperature.
Do not pour liquid or solid matter into the tank, air gap at the top of the
glass is necessary due to heat expansion.
Do not move or shake the lamp during operation. Operate it on a stable and
flat level.
The lamp warms up during the operation. Keep it away from small children and
pets.
If you want to relocate the already switched-on lamp, wait until it cools
down.
The coloured wax may float on the surface of the liquid, which is caused by
overheating of the wax. In such cases switch off the lamp, then after 1 hour
switch it on again.
The coloured wax may float at the bottom of the liquid, which is caused by the
too-low room temperature. Place the lamp into a room with the specified
temperature, where it will properly operate.
During regular use, the colour of the wax may fade.
The liquid tank is made from glass. The contents of the glass: distilled
water, wax colouring agent triphenylmethane+monomethine
Avoid contact with the skin and eyes. Contact with eyes and skin may cause
mild irritation and rubedo. Flush liquid caught in the eyes with plenty of
cold water. Flush liquid caught on the skin with plenty of water and soap. See
your physician if irritation persists.
Do not swallow the contents of the glass. In case you swallow the fluid, see
your physician urgently. Vomiting is not recommended.
The content of the glass is not flammable or explosive
The content of the glass is not caustic
Do not pour the content of the glass into conduits
Bear in mind that light sources are hazardous waste. Always keep separate the
household waste and dispose only at the appointed collection points!
Our products comply with the relative European standards in each case (EN
60598)
MANUAL LAVA_CLASS_G_20210614_40_01.indd 2
2021.06.21. 11:27:33