FALCON RIDGE KY-UXV500-RW01 Kymco UXV 500 Soft Rear Window Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE KY-UXV500-RW01 Kymco UXV 500 Soft Rear Window
2515 KY HWY 11 Bypass Rd. Flemingsburg, KY 41041 606-845-7439
Instructions for Installation and Care of Kymco UXV 500 Soft Rear Window KY-UXV500-RW01
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.
INSTALLATION
- Be sure to read these instructions thoroughly before opening and installing the Kymco UXV500 Soft Rear Window. The installation is best done when the temperature is 70 degrees F. or warmer. The temperature affects the adhesive Velcro, if conditions prevent installing in warmer weather it helps to store the adhesive Velcro at room temperature prior to installation.
- Carefully open the carton and remove the enclosure on a large flat surface that is clean and free of dirt.
- Check over the parts included in the carton with the parts list shown below:
- Adhesive Velcro Hook Strips: 2 each————3”
- 2 each————6”
- “ “ “ “ 2 each————12”
- “ “ “ “ 2 each————24”
- “ “ “ “ 1 each————48”
- Cab Enclosure 1 panels
- The sides of the Rear Window are held in place by two Velcro straps on each side. You need to wrap the roll cage with one of the 3” adhesive Velcro strips first and then wrap the double-sided Velcro around the adhesive strip to provide a secure hold. Below are photos showing how these should look.
- Take the two 18” adhesive Velcro strip and install it along the top of the top bar running from side to side. Please see photo below for reference.
- Now install Velcro straps sewn to the sided at the top and bottom. You may need to remove the strap on the door to get the adhesive Velcro in place. See Photos below.
- Now install the two 12” adhesive strips for the bottom of the Rear Window. The best method is to attach the strip to the Velcro on the rear window and then remove the paper to expose the adhesive. Then push the bottom of the Rear Window on to the vehicle to attach the adhesive strip to the plastic.
- Now take the two 80” cords and lace the Rear Window to the roll cage. Tie the end of the cord to the top hole and begin to wrap the cord around the bar and back through the top hole. Then wrap the bar with the cord moving down the bar tying the end off at the bottom. Be sure to melt the ends to prevent fraying. The photo below show how this should look.
Cleaning and Storage Recommendations
- Before removing the Falcon Ridge Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll for storage.
- It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory. On a large, clean and flat surface, fold the doors over the rear panel first, then, interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter. Put the rolled Cab back into the carton for storage at a normal room temperature. It is best not to expose the Cab to either extreme hot or cold temperatures when storing.
- A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered.
Return Policy
If for any reason you choose to return this product it must be returned within 30 days from the date the item is received. You MUST package the product exactly as it was originally packaged from the factory to get a full refund for the product! The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the windows. All returned products will be inspected upon arrival at the production facility and must be in unused, factory-new condition to receive a refund – a 25% restocking fee will apply. If ordered from Falcon Ridge please call at 606-845-7439 to gain a return authorization number, use our preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying the shipping to return the item.) Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge’s many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory-new condition.
NOTE: All windshields must be returned with the original protective film intact and not removed. Do NOT REMOVE if you have any intentions of returning the item. Refund/ replacement of a windshield will only be processed on items with original protective film or if the windshield is defective. Items must be properly packaged in the original shipping carton to protect them during transit and ensure your returned item arrives back factory fresh, and in new resalable condition (any returned items that have been used, altered or damaged in any way will not be subject for a refund.) All contents including instruction manuals, accessories, hardware, Velcro, etc. must be included in your return shipment. Only items in OEM factory new condition will be approved. Once returned items are received, credit will be issued to the original credit card/ payment method used for the purchase. Outbound shipping and return shipping cost will not be refunded. Please allow 4 to 6 weeks for your refund to be processed.
Warranty
To The Owner of this Product: Thank you for purchasing one of Falcon Ridge’s Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty. 30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to defects in the product. Please refer to the return policy in this case for more information. 1 Year Warranty includes any defect in material or workmanship within this time frame we will gladly correct the problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of purchase.
Thank you, Falcon Ridge
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>