GoGEN TWS MATE B Wireless Headphones User Manual

TWS MATE B

WIRELESS STEREO HEADPHONE
USER MANUAL

SECURITY PRECAUTIONS

In order to have a proper and safe use of the headset, please read this user manual in detail and save it. Be aware of the following guidelines when using your headset:

WARNING

• You should adjust the volume carefully when using the headset to prevent hearing damage.
• Please stop using the headset in potentially hazardous situations to ensure your safety.
• Please avoid using the headset to listen to music, make or receive calls which may cause a distraction while driving.
• Put this product and its accessories somewhere out of the reach of children, to avoid a fatal danger caused by inappropriate use.
• You should keep water from entering the headset, which may cause damage to the sound quality or the headset.
• You should avoid turning the volume so high that you can’t hear anything around you. If you feel a tinnitus or the volume is too high, please reduce the volume.
• Stop using the headset if you feel obvious discomfort, irritation or have other adverse reactions.
• The headset should not be stored or used at temperatures below -10 °C or above 55 °C which may shorten headset or battery life.

TECHNICAL SPECIFICATIONS

Bluetooth Version: V 5.0
Bluetooth Profile: HSP, HFP, A2DP, AVRCP
Operating range: 10 m
Frequency Response: 20 Hz – 20 KHz
Rated Power: 5 mW
Sensitivity: 92 dB (±3 dB) @ 1 KHz
Impedance: 16 Ω ± 15%
EIRP: 3,35 dBm
Battery: Li-Polymer 450 mAh Charging Case + 50 mAh X 2 earbuds
Music playing time: up to 6 hours + 18 hours with charging case N.W.: 4,6 g / earbud, 32,6 g including charging case

ACCESSORIES

Eartips, USB Charge Cable, Charging Case

DEVICE LAYOUT

1. Touch control area
2. Mic
3. Charging interface
4. Charging case battery indicator

POWER ON & PAIRING

Option 1: AUTO ON & PAIRING
With the two headsets in case and lid open to active Power ON. Take out the headsets and wait about 10 seconds until LEFT & RIGHT earbuds AUTO paired.
Option 2: Manually ON & PAIRING
Pick up the headset from the charging case, long tap the L&R earbuds for 3-5 seconds until they powered OFF (The indicator of each earbud will flash RED for 1 second). After a while (5 seconds), long tap the L&R earbuds for 3-5 seconds until the indicator of each earbud flashing BLUE for 1 second (means Power ON ), and keep taping for 3 seconds to enter into pairing mode (The RED and BLUE indicator flashes rapidly). When L&R pairing is successfully done, the R earbud is working as a Master. The L is working as a Slave. There are no lights after successfully connecting.

RESET

In case of failure pairing or unnormal working, you need to RESET the earbuds as following: Take out both earbuds from charging case and power off them manually, then long press 15 seconds to reset the earphones. After reset them successfully, put them into the charging case. And your earphones are ready for AUTO ON & Pairing.

BLUETOOTH CONNECTION STEPS

1. Please keep your headset and mobile phone as close as you can, within 1 meter.
2. Turn on “Bluetooth” in setting on your phone or other devices, and then find and select GOGTWSMATEB.
3. Click on GOGTWSMATEB and Bluetooth Headset gets connected with your phone or devices automatically. (Some may require a passcode which is “0000” (4 zeros)).

TAP CONTROL INSTRUCTIONS

long for 3 seconds manualy
ACTIVATOR ON| CONNECTING TO PHONE| Press 3 times on the L or R earphone to enter Sin or Go-ogle Assistance
ACTIVATOR OFF| CONNECTING TO PHONE| Press 1 time on the L or R earphone to quit Sid or Google Assistance
ANSWER CALL| INCOMING CALL| Short press the L or R earphone
END/REJECT CALL| ON CALL| Long press L or R earphone for 2 seconds
LAST NUMBER REDIAL| CONNECTING TO PHONE| Press 4 times on the L or R earphone
PLAY & PAUSE MUSIC| MUSIC PLAYING| Short press L or R earphone
---|---|---
VOLUME UP| MUSIC PLAYING| Double press R earphone
VOLUME DOWN| MUSIC PLAYING| Double press L earphone
PREVIOUS TRACK| MUSIC PLAYING| Press L earphone for 2 seconds
NEXT TRACK| MUSIC PLAYING| Press R earphone for 2 seconds
AUTO OFF| EARPHONES ON| Disconnect with phone over 5 minutes
RESET| EARPHONES OFF| Long press L/R earphones for 15 seconds until voice bee and put into case

CHARGING

CHARGING WAYS OF HEADSET
Put the headset(L)(R)to the corresponding position in the bottom of the charging base, close the charging base tightly. The indicator light of headset is red when being charged, and will turn off automatically after being fully charged.
CHARGING WAYS OF CHARGING BASE

Use the USB charging cable to charge. The indicator light of charging base is flashing white when being charged, and lights white after being fully charged.

WARNING:

• You must select a qualified charger from a regular manufacturer. (Charging Voltage: 5V Charging Current: 900mA for charging case)

• A fully charged headset will lose its power automatically if left unused. It is recommended to charge the headset each three months.

• Do not leave the headset in a too hot or too cold condition (best between -10°C and +40°C) which may affect the headset‘s operations although it is fully.

• Please wear this Headset properly for best tone quality.
  Do not disassemble hardware. Please use soft and dry cottons for cleaning.

• Make sure the headset is fully charged before first use.

• This Headset is not waterproof. Do not use it while swimming or diving.

• If do not use this Headset for long time, please charge once a week to extend battery life.

• Keep your Headset and device as close as you can to avoid interference of signal path.

WARRANTY
Our product is warranted for 2 full year from the date of purchase. The warranty is provided on all material defects and workmanship. Guarantee of 24 months does not apply to decrease in the accumulator’s effective capacity caused by its use or age. Effective capacity gradually decreases depending on the method of use of the accumulator.

WE RESERVE THE RIGHT TO CHANGE TECHNICAL SPECIFICATIONS.

TO AVOID DANGER OF SUFFOCATION, KEEP THE PLASTIC BAG AWAY FROM BABIES AND CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS, CARRIAGES OR PLAYPENS. THIS BAG IS NOT A TOY.

Disposal of old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product.

Hereby, ETA a.s. declares that the radio equipment type TWSMATE is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://www.gogen.cz/declaration_of_conformity

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>