FALCON RIDGE PO-08&09CREW-WTC01 Full Size Polaris Ranger Crew Soft Windshield & Top Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE PO-08&09CREW-WTC01 Full Size Polaris Ranger Crew Soft
Windshield & Top
Instructions for Installation and Care of Polaris 08/09 Ranger Crew Windshield Top Combo PO-08&09CREW-WTC01
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.
- Be sure to read these instructions thoroughly before opening and installing the Polaris Ranger Cab Enclosure. The installation is best done when the temperature is 70 degrees F. or warmer.
- Carefully open the carton and remove the rolled up Cab Enclosure on a large flat surface that is clean and free of dirt or other material that may soil or scratch the windows of the Cab.
- It will help to unhook the hood prior to installing the cab enclosure
- Check over the parts included in the carton with the parts list shown below:
- Before putting the Windshield Top Combo over the roll cage there are several pieces of adhesive Velcro that should be installed first. Open the front hood of the Crew and prop it up with something or have someone hold it up. Across the bottom of the dash you will be placing the 30” (1” wide) and 2 – 10” (1” wide) strips as shown in the photos below.
- Now loosely drape the Windshield Top Combo over the Ranger Crew roll cage. While having someone holding the hood up or propping it up, slip the middle nosepiece between the hood and dash and attach it to the adhesive Velcro underneath the dash. Next pull the side nosepieces under the dash andattach to Velcro there. Finished look should be like photos below.
- Now pull down on both sides of the rear of the top and mark how far down it will go and wrap the roll cage with the 6” Velcro strips. You can now pull it down and wrap the double-sided Velcro strips around the adhesive strips as shown in the photos below. The same will apply to the middle bar on the sides of the cab.
- Note the position and install two 10” and one 5” hook and loop strips on both sides of the roll cage for the front window. Be certain to clean the surfaces before applying the adhesive hook strips! Pull the window tightly toward the sides to minimize waviness or wrinkles in the front window and attach.
Cleaning and Storage Recommendations
- Before removing the Falcon Ridge Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll for storage.
- It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory On a large, clean and flat surface, fold the doors over the rear panel first, then, interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter. Put the rolled Cab back into the carton for storage at a normal room temperature. It is best not to expose the Cab to either extreme hot or cold temperatures when storing.
- A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered.
Finished Installation
Return Policy
If for any reason you choose to return this product it must be returned within 30 days from date item is received. You MUST package the product exactly as it was originally packaged from the factory to get a full refund for the product! The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the windows.
All returned products will be inspected upon arrival at the production facility and must be in unused, factory new condition to receive refund – a 25% restocking fee will apply. If ordered from Falcon Ridge please call at 606-845-7439 to gain a return authorization number, use our preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying the shipping to return the item.) Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridges many distributors’, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory new condition.
NOTE: All windshields must be returned with the original protective film intact and not removed. Do NOT REMOVE if you have any intentions of returning the item.
Refund/ replacement of a windshield will only be processed on items with
original protective film or if the windshield is defective.
Items must be properly packaged in the original shipping carton to protect
them during transit and ensure your returned item arrives back factory fresh,
and in new resalable condition (any returned items that have been used,
altered or damaged in any way will not be subject for a refund.) All contents
including instruction manuals, accessories, hardware, Velcro, etc. must be
included in your return shipment. Only items in OEM factory new condition will
be approved. Once returned items are received, credit will be issued to the
original credit card/ payment method used for the purchase. Outbound shipping
and return shipping cost will not be refunded. Please allow 4 to 6 weeks for
your refund to be processed.
Warranty
To The Owner of this Product
Thank you for purchasing one of Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty. 30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to defect of the product. Please refer to the return policy in this case for more information.
1 Year Warranty includes any defect in material or workmanship within this time frame we will gladly correct the problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of purchase.
Thank you,
Falcon Ridge