FALCON RIDGE BC-2200-WD02 Bobcat 2200 Full Lexan Windshield Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE BC-2200-WD02 Bobcat 2200 Full Lexan Windshield
NOTICE:
Please check the contents of the package for any damage and make sure all
parts fit correctly and you are happy with the product before removing the
protective film. Once the film is removed you cannot return the product for a
full refund.
Be sure to read these instructions thoroughly before opening and installing the windshield.
PARTS
Check over the parts included in the cartons with the parts list shown below:
- 2” clamps 8 each
- 1” Bolts 8 each
- Washers 24 each
- Thumbnuts 8 each
- Rubber Gasket 1 each
- Lexan brace 1 each
- Lexan windshield 1 each
INSTALLATION INSRUCTION
-
Start by pulling it out of the box; find a clean area to lay it down and install the hardware. Next take the rubber gasket and starting at one end firmly place along entire bottom edge of the windshield. You will need to peel back the protective film from the edge to install the gasket. If you leave the bulk of the protective film on while installing you can avoid scratching the windshield. Ensure that the gasket is seated fully home on the bottom edge hood contour of the windshield.
-
Next take the bent Lexan brace and install it on the windshield. It will go on the outside at the top of the windshield. The bend will be above the bolts when installed. See fig.1.
-
Now you are ready to place the windshield on the vehicle and attach to the roll cage.
NOTE: THE BEND AT THE TOP OF THE WINDSHIELD SHOULD GO BELOW THE TOP TUBE. Install windshield clamps at all windshield slot locations in accordance .
-
Enjoy, and remember- when cleaning the windshield do so gently at first with warm water and mild detergent to dislodge any grit that may scratch the Lexan. After rinsing and drying with a soft cloth, you may then polish the windshield with an appropriate commercially available plastic polish, also available from Ape Offroad. This will ensure many seasons of clarity and keep scratching and swirling to a minimum. Never use cleaners such as Windex that contain ammonia as doing so may adversely affect the windshield.
-
If needed, additional Velcro sets are available, as well as other spare parts and hardware. Contact Ape Offroad for information.
-
Transporting or trailering your UTV with the windshield installed is not generally recommended. It is best to remove the windshield before transporting your UTV.
Return Policy
If for any reason you choose to return this product it must be returned within 30 days from the date the item is received. You MUST package the product exactly as it was originally packaged from the factory to get a full refund for the product!
The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the windows. All returned products will be inspected upon arrival at the production facility and must be in unused, factory-new condition to receive a refund – a 25% restocking fee will apply. If ordered from Falcon Ridge please call at 606-845-7439 to gain a return authorization number, use our preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying the shipping to return the item.) Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge’s many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory-new condition.
NOTE:
All windshields must be returned with the original protective film intact and
not removed.
Do NOT REMOVE
If you have any intentions of returning the item. Refund/ replacement of a
windshield will only be processed on items with original protective film or if
the windshield is defective.
Items must be properly packaged in the original shipping carton to protect them during transit and ensure your returned item arrives back factory fresh, and in new resalable condition (any returned items that have been used, altered or damaged in any way will not be subject for a refund.) All contents including instruction manuals, accessories, hardware, Velcro, etc. must be included in your return shipment. Only items in OEM factory new condition will be approved. Once returned items are received, credit will be issued to the original credit card/ payment method used for the purchase. Outbound shipping and return shipping cost will not be refunded. Please allow 4 to 6 weeks for your refund to be processed.
Warranty
To The Owner of this Product:
Thank you for purchasing one of our Falcon Ridge Cab Enclosures, Tops &/or
Windshields! Below are the terms under which your product is covered under our
manufacturer’s warranty.
30 Day Warranty which includes and is not limited to replacing the enclosure,
tops, and/or windshield due to defects of the product. Please refer to the
return policy in this case for more information. 1 Year Warranty includes any
defect in material or workmanship within this time frame we will gladly
correct the problem or replace the enclosure, tops &/or windshield. Upon
submitting for the correction or replacement we will need to receive pictures
of the defect in material or workmanship along with the receipt from the date
of purchase.