FALCON RIDGE KAW-PROFXT-MRW01 Kawasaki Pro FXT Middle Rear Window Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE KAW-PROFXT-MRW01 Kawasaki Pro FXT Middle Rear Window
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. The cab is Flammable.
INSTALLATION INSTRUCTION
-
Be sure to read these instructions thoroughly before opening and installing the Kawasaki Pro FXT Front Door Middle Rear Window Combo The installation is best done when the temperature is 70 degrees F. or warmer. The temperature affects the adhesive Velcro, if conditions prevent installing in warmer weather it helps to store the adhesive Velcro at room temperature prior to installation.
-
Carefully open the carton and remove the enclosure on a large flat surface that is clean and free of dirt.
-
Check over the parts included in the carton with the parts list shown below:
Adhesive Velcro Hook Strips:- Middle Rear Window
“ “ “ “ 2 each————45”
“ “ “ “ 1 each————48”
“ “ “ “ 1 each————60”
- Middle Rear Window
-
Begin by Cleaning the roll cage. Using rubbing alcohol is preferable. This step is very important for the Velcro strips to properly adhere.
-
The middle rear window is put in place by the 48″ adhesive Velcro strip across the top and the 60″ adhesive strip across the bottom. Place the two strips on the vehicle as shown in the following pictures on the next page.
-
Next take the two 45″ adhesive Velcro strips and put them on the roll cage on either side of the Middle Rear Window. You may need to cut the Velcro to fit around the rear grab bar. The following photos show how this should look.
Cleaning and Storage Recommendations
- Before removing the Falcon Ridge Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll for storage.
- It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory. On a large, clean, and flat surface, fold the doors over the rear panel first, then, interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter. Put the rolled Cab back into the carton for storage at normal room temperature. It is best not to expose the Cab to either extremely hot or cold temperatures when storing.
- A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if the additional hook and loop sets are needed, they can also be ordered.
Return Policy
If for any reason you choose to return this product it must be returned within 30 days from the date the item is received. You MUST package the product exactly as it was originally packaged from the factory to get a full refund for the product!
The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the windows. All returned products will be inspected upon arrival at the production facility and must be in unused, factory-new condition to receive a refund – a 25% restocking fee will apply. If ordered from Falcon Ridge please call at 606-845-7439 to gain a return authorization number, use our preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying the shipping to return the item.) Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge’s many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory-new condition.
NOTE:
All windshields must be returned with the original protective film intact and
not removed.
Do NOT REMOVE
If you have any intentions of returning the item. Refund/ replacement of a
windshield will only be processed on items with original protective film or if
the windshield is defective.
Items must be properly packaged in the original shipping carton to protect them during transit and ensure your returned item arrives back factory fresh, and in new resalable condition (any returned items that have been used, altered or damaged in any way will not be subject for a refund.) All contents including instruction manuals, accessories, hardware, Velcro, etc. must be included in your return shipment. Only items in OEM factory new condition will be approved. Once returned items are received, credit will be issued to the original credit card/ payment method used for the purchase. Outbound shipping and return shipping cost will not be refunded. Please allow 4 to 6 weeks for your refund to be processed.
Warranty
To The Owner of this Product:
Thank you for purchasing one of our Falcon Ridge Cab Enclosures, Tops &/or
Windshields! Below are the terms under which your product is covered under our
manufacturer’s warranty.
30 Day Warranty which includes and is not limited to replacing the enclosure,
tops, and/or windshield due to defects of the product. Please refer to the
return policy in this case for more information. 1 Year Warranty includes any
defect in material or workmanship within this time frame we will gladly
correct the problem or replace the enclosure, tops &/or windshield. Upon
submitting for the correction or replacement we will need to receive pictures
of the defect in material or workmanship along with the receipt from the date
of purchase.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>