Klim K140 Gaming Desk User Manual
- June 5, 2024
- KLIM
Table of Contents
Klim -K140 -Gaming -Desk
SAFETY WARNINGS
IMPORTANT SAFETY WARNINGS
Before the first use, ensure that all parts are assembled properly and all screws are firmly tightened. Check the table stability regularly and tighten any screws that may have become a bit loose after long periods of use. Do not place excessive weight on the table, as it could become damaged or even break, causing material and/or personal injury. Do not step on any parts of the table or lean your weight on the tabletop to avoid damage on the table or personal injury. Always keep the lighting control panel, light frames and wires dry to prevent any malfunction or electrical/fire hazard. In case of liquid spillage in this area, unplug the USB cable and ensure all components are dry before plugging it again. This gaming desk is intended for indoor use only. Avoid excessive exposure to sunlight and humid environments both during usage and storage.
CONTENTS
GAMING DESK
ASSEMBLY GUIDE
IMPORTANT: assemble the desk on a hard, flat surface. It is placed upside down for an easier assembly: we recommend placing a protective mat or cloth sheet to avoid staining or damaging the table or other surfaces.
Place the two legs upside down and attach the two H-shaped connecting frames to the table legs using the four 6 x 50 mm screws. Pay attention to the orientation of the frames so you can attach the diagonal connectors in the next step.
Attach the diagonal connectors to the table legs and the frames using one 6 x 16 mm screw for each rod and one 8 x 50 mm screw + 8 mm nut for each leg.
Place the two tabletop halves upside down on a flat surface and attach the legs to the tabletop halves using two M4 x 40 mm screws for each half.
Align the two halves of the tabletop and place the segment connectors above the H-shaped frames. Align every hole on the tabletop and the rods, then use six 6×16 mm screws and washers to attach the connectors to the H-shaped frames, and six M4 x 16 mm screws to secure all the pieces to the tabletop.
Attach the two connecting plates to the tabletop using M4 x 16 mm screws. Attach the wire holder to the back of the tabletop using M4 x 16 mm screws. Firmly screw the four feet to the table legs by hand, then carefully put the gaming desk up on its feet.
Attach the table frames to the two back corners of the table using three M4 x 16 mm screws on each side. Attach the cup holder and headset holder to the top part of the legs at each side of the table using one 6 x 16 mm screw.
Put the two cable hole covers in their place. Insert the lighting control panel in the socket at the top-left corner of the table, then use the three- point cable to connect the control panel and the two frames. Leave the USB cable accessible so you can plug it to your computer once you install your setup
Hide the cable going from one lighting frame to the other with the long wire holder. Attach the adhesive cable hooks anywhere under the desk according to your needs. We recommend doing this after you’ve finished setting up your computer and peripherals for neater cable management.
LIGHTING CONTROLS
- Press and hold the ON/OFF for two seconds to turn the lights on and off.
- Briefly press the ON/OFF button to cycle through each of the 8 brightness levels.
- Press the RGB button to change the lighting color scheme.
Thank you for acquiring our KLIM K140 Gaming Desk! We hope that you enjoy your new setup for years to come. May you finish all your work in time, and win every match you play! If you need any help during assembly or use, or if you simply want to share your feedback, do not hesitate to reach out to us directly at support@klimtechnologies.com. Our specialists will reply within 24 hours!
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>