BISSELL 3011 Crosswave X7 Cordless PRO Battery Removal Instructions
- June 6, 2024
- Bissell
Table of Contents
CROSSWAVE® X7 CORDLESS PET PRO
BATTERY REMOVAL INSTRUCTIONS 3011, 3276, 3277, 3279 SERIES
Disposing of the Battery
Needed for Disassembly: · Phillips-head Screwdriver · Electrical tape
Before disposing of the battery, make sure:
The machine is disconnected from the docking station.
The clean and dirty water tanks are empty or removed from the machine.
1. Remove the Clean Water Tank and the Dirty Water Tank.| 2. On the back of
the machine, press the button under where the handle fits into the machine
while pulling the handle up.| 3. Remove the product face with a screwdriver
by sliding a screwdriver between the face and the body of the product.
4. Remove two screws under the front face of the machine body. Remove 11
screws that attach the front cover to the body of the product.| 5. Use a
screwdriver to remove the 3 screws holding the battery in place. Remove the
battery pack.| 6. The front cover and the body of the product are attached by
three connectors.
7. Unplug the yellow connector from the body of the product.| 8. Unplug the
orange connector from the body of the product.| 9. Unplug the red and black
wired connector.
10. Remove the battery pack from the product.| 11. After the connectors are
disconnected from the body of the product.| 12. Use electrical tape to tape
the end of the connectors and recycle the battery.
©2022 BISSELL Inc. All rights reserved. Part Number 1627863 11/21 RevB
NOTICE Disconnecting the battery will destroy the appliance and
invalidate the warranty.
WARNING This product contains Lithium-Ion rechargeable batteries. DO NOT
mix Lithium-Ion batteries with general household waste. According to Federal
and State regulations, removal and proper disposal of Lithium-Ion batteries is
required. For specific battery disposal instructions please contact
Call2Recycle at 877-723-1297 or visit
www.call2recycle.org.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>