Klim Discman Portable CD Player with Built-in Battery User Manual

: June 5, 2024
: KLIM

Table of Contents

Klim Discman Portable CD Player with Built-in Battery User Manual
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Klim Discman Portable CD Player with Built-in Battery User Manual

Discman

Important Safety Instructions

Please read this manual carefully before using this player and keep it for later reference.

THE CD PLAYER

If the player fails to work, please contact our customer support team on support@klimtechnologies.com, our staff will be happy to resolve your problems. Remember that the KLIM Discman is supported by our warranty.
The device cannot be used or stored in moist environments. Keep the device away from any liquid, steam, etc.
Do not place any liquid or unintended objects other than CDs into the player.
Do not expose the device to sunlight and keep it away from heaters. The player is not intended to be stored or used in high temperature environments.
All professionals with extensive electronic knowledge and maintenance experience are allowed to disassemble the player for maintenance. The replacement of spare parts must be done in strict accordance with the parameters of the circuit design.
Do not scratch or hit the player with sharp objects.
There are light emitting diodes in this device. Do not look directly into the lens; such exposure may cause permanent eye damage.
Children under the age of 12 should be supervised by an adult when using this device.

BATTERY

Do not disassemble the device or charge the device with power adapters that do not meet the electrical parameters of this product to avoid permanent damage. For your safety, please handle the built-in high-capacity polymer lithium battery by following the instructions below:

Do not remove the battery pack.
Do not drop or expose the device to any physical impact.
Do not short circuit or pierce the battery.
Do not place the player under ambient temperatures above 131°F (55°C).
Do not put the battery in a fire. 6. If the battery has been damaged, ask a professional to replace the battery with the same specifications, or contact our customer support team.

HEARING SAFETY WARNINGS

Adjust the volume to an appropriate level. If the volume is too high, it may damage your hearing or even cause permanent damage. You should increase the volume slowly, until a comfortable, clear sound can be heard.

Listening to an audio device, even at a reasonable volume, may cause hearing damage if done for extended periods of time. Please use the device in moderation and allow for adequate rest for your ears.

Package Content and Product Diagram

Package Contents and Product Diagram

TECHNICAL SPECIFICATIONS

Technical Specifications

Contact and Troubleshooting

Please refer to page 8 for common issues and solutions when operating the KLIM Discman. In case you require additional assistance or have any questions, please write us directly to our email address at support@klimtechnologies.com.

First Use

INSERTING AND REMOVING DISCS

Push the OPEN button on the right to open the cover. Insert your index finger into the center hole of the disc and take the edge of the disc with your thumb. Keep the labeled side upward while inserting the disc into CD player and press the disc gently to lock it in place.

Close the disc cover completely, otherwise the player will not read the disc.

To remove an inserted disc, gently pull it upwards from the side.

Note: The player is only compatible with CD, CDR, Mp3, HDCD formats.

USING EARPHONES

Only earphones with a 3.5 mm jack are compatible with this device. In order to experience the best sound quality, please use the included KLIM Fusion or similar high fidelity headphones.

For reference, you may find the KLIM Fusion manual on our website at www.klimtechs.com/manual

TURNING ON THE PLAYER

The power switch is located on the side. Slide it to the ON position to play normally. When the last track in a disc is played or there is no disc in the unit, the player will enter standby mode after 20 seconds. Press the PLAY button again to restart the player.

HOW TO TURN OFF THE PLAYER

There are two ways to turn off the player:

Move the power switch to the OFF position if the player will not be used for an extended period of time.
The player will enter standby mode by pressing the STOP button twice in succession. On standby, the player will continue to consume some power, since it is not completely switched off.

IMPORTANT: while on standby mode, press the Play/Pause button to reactivate the player.

CHARGING THE PLAYER

This product is equipped with one charging cable. You can use any charger that supports USB 2.0 protocol or standard USB charger to charge the player.

Charging time: It takes around 4 hours to fully charge the player (this varies depending on the power output). When the battery is being charged, the LED indicator is red. Once the player is fully charged, the LED indicator will turn green.

Playback Options

HOW TO SETUP REPEAT MODE

Each time the MODE button is pressed, the order of the tracks played will be as follows: Repeat 1(REP1) will loop a single track. Repeat all (ALL) loops the playlist. Shuffle (SHUF) randomly plays tracks, Preview (INTRO) plays only the first 10 seconds of each track.

SAVING TRACK PRESETS

Use the PROG (4) button to enter the programming mode. Press STOP (8), then select the track you want to program using the Next/Previous buttons. Press PROG (4) to assign the track. Press PROG (4) again to assign the next track, and repeat the process to assign up to 30 pre-selected tracks. At any point, press the PLAY (7) button to enter the programming play mode. Press the STOP (8) button directly to enter the stop mode to cancel or reprogram.

HOW TO PLAY AN MP3 DISC

Press DIR (3) to choose different folders if there are multiple folders on the inserted disc.

Other Features

VOLUME ADJUSTMENT

Use the volume knob located on the side of the player to decrease or increase the volume. Remember to use a reasonable volume level to avoid any hearing damage.

KEY LOCK

After playback mode and sound settings have been selected, you can move the HOLD switch to the ON position in order to prevent changing the settings of volume by accidentally pressing any key. This is particularly useful when doing sports.

DISPLAY SLEEP FUNCTION

The display screen will be turned off after 10 second of inactivity. The screen will be turned back on when any button is pressed.

LAST MEMORY

ON: The player will return to the last played moment on the disc.

OFF: The player will not return to the last played on the disc.

Press and hold the PROG (4) button to turn the last memory function on or off. The ON or OFF word will be displayed on the screen at this time. The last memory function is turned on by default.

Last Memory

EUQALIZATION

Press the EQ (9) button to change the different sound effects. There are a total of 5 sound effects to choose from: BBS, POP, JAZZ, ROCK and CLASSIC.

A-B POINT FUNCTION

W 15 hen playing MP3 or CD discs, press this button once to mark an A point, then press the button again to make a B point. The unit will repeat playing the audio between point A and point B. Press the button again to cancel.

Note: Point A and Point B must be within the same song.

CONNECTION TO AUX DEVICES

In order to use this player in different settings, an AUX cable has been supplied to connect this player to any device with an AUX interface, such as: surround systems, home theatre, vehicles, headphone amplifiers and other devices.