Kenmore 111 model top-freezer refrigerator error codes
- June 5, 2024
- Kenmore
Table of Contents
Kenmore 111 model top-freezer refrigerator error codes
These error code explanations help troubleshoot a problem with your Kenmore top-freezer refrigerator with a model number that starts with 111. The LED light on the main control board flickers a number of times then pauses to indicate an error code. Remove the main control board cover to view the LED light and count the flickers. To avoid getting shocked, don’t touch anything inside the refrigerator while you have the control board cover removed because the main control board is connected to electricity when the refrigerator is plugged in.
Unplug the refrigerator to disconnect power and reinstall the control board cover after counting the LED flickers. Find the error code in the chart below and repair the failure.
| Error Code | Condition | DIY Advice |
|---|---|---|
| Main control board LED flickers 1 time | Refrigerator temperature sensor | |
| failure |
Check/Repair
The refrigerator temperature sensor attaches to the back wall inside the refrigerator compartment. Unplug the refrigerator and check the temperature sensor wiring connected to the control board for damage and repair any broken wires. Measure the resistance through the refrigerator temperature sensor circuit from the control board. Replace the refrigerator temperature sensor if resistance isn’t between 5,000 and 40,000 ohms.
Main control board LED flickers 2 times| Ambient temperature sensor failure|
Check/Repair
The ambient temperature sensor (also called RT-sensor) attaches to the top of the refrigerator. Unplug the refrigerator and check the temperature sensor wiring connected to the control board for damage and repair any broken wires. Measure the resistance through the ambient temperature sensor circuit from the control board. Replace the ambient temperature sensor if resistance isn’t between 5,000 and 40,000 ohms.
Main control board LED flickers 3 times| Defrost temperature sensor failure|
Check/Repair
The defrost temperature sensor monitors evaporator temperature. Unplug the refrigerator and check the temperature sensor wiring connected to the control board for damage and repair any broken wires. Measure the resistance through the defrost temperature sensor circuit from the control board. Replace the defrost temperature sensor if the resistance isn’t between 5,000 and 40,000 ohms
Main control board LED flickers 4 times| Control senses refrigerator door open for more than 1 hour|
Check/Repair
Unplug the refrigerator and check the wiring between the door switch and the control board. Reconnect any loose wires and repair any broken wires. If the wiring is okay, unplug the door switch wire harness from the control board. Check for continuity through the door switch with the plunger pushed in. If you don’t measure continuity, replace the door switch.
Main control board LED flickers 6 times| Defrost heater failure|
Check/Repair
Measure the resistance through the defrost heater circuit from the control board. Replace the defrost heater if resistance isn’t between 50 and 70 ohms.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>