novostella NTS33-CW-US-NF LED Light Strip User Guide

novostella NTS33-CW-US-NF LED Light Strip User Guide

LED Light Strip

THANK YOU for choosing Novostella. To optimize user experience, please install and use the light according to the following instruction.

ZIS, Warning

1. Winding lighting is prohibited, as it affects heat dissipation and might cause dangers.
2. Please unroll the light strip from the plate before lighting it up.
3. To ensure it works properly, the light strip can not be extended and must keep the total installation length within its maximum (6m/12m/24m).
4. Please check if the light strip and the parts are intact before using them.
5. Please make sure that the power supply is turned off before installation.
6. To ensure that the light works properly, please use the voltage indicated on the packing.
7. Please do not use this light in the open air or under humid environment.

1. Specification

2. Components

3. Installation

1. How to cut the LED strip? Before cutting the LED strip, please keep

these in mind.

1. Once the strip is cut, an extra connector is needed for reconnection, otherwise the rest part being cut can not work.
   The connector is not included in the package. You may contact the seller for the connector details.

2. Double confirm the length for installation before making the cut.

3. Cut the strip along the marks.

2. How to install the LED strip?

(1) Choose an even and smooth surface.

NO Knitted or Wool Fabrics                       NO Plastered Wall

(6) Connect the light stripC)to controller cable C), and then connect controller cable to power adapter ®. Plug the adapter into the socket and turn on the light strip by pressing ‘ON’ button on the RF remote controller.

Note:

1. If the strip can’t light up after the installation, please check whether the joints are connected correctly.
2. Please make sure to turn off the power supply during routine maintenance.
3. To avoid any damage to the strip, please do not use chemical solvent during routine maintenance.

4. Instructions on RF remote controller.

The remote controller can control either one strip or many strips under different settings.
C)One-to-One Setting: one remote controller can control only one light strip. When the controller is on, during the first 5 seconds, immediately long press the bottom left button till the strip blinks, which means the “One-to-One” setting is done. ®One-to-Many Setting: one remote controller can control two or more light strips. When the controller is on, during the first 5 seconds, immediately long press the bottom right button till the strip blinks, which means the “One-to-Many” setting is done.

FCC ID : 2AWON-NTS-CW

Warning Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help.

Manufacturer: Shenzhen Ustellar Technology Ltd.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>