ZENEC Z-E3756 Naviceiver for Flat Ducato Instruction Manual

: June 3, 2024
: ZENEC

Table of Contents

Requirements
Improvements and Bugfixes
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ZENEC Z-E3756 Naviceiver for Flat Ducato Instruction Manual

Requirements

The update consists of a complete MainSystem software update, which must be run from USB data carrier. You will need:

USB removable storage device (USB stick) with at least 2 GB storage capacity.
A PC or notebook with Windows operating system.

Please note: Before you start, the USB stick must be formatted with FAT 32. (Right-click on USB memory device in Windows Explorer. Select “Format” > FAT 32 > Start.

(!) The ZENEC Z-E3756 restarts several times during the software update and stays off, among other things, for a few seconds (black screen for approx. 10 ~ 15 sec.) before the device restarts. Please do not operate or switch off the device during the update process. After successful installation the tuner source will come up.

Installation of the MainSystem software update via USB:
The MainSystem software can be found at: www.zenec.com> Support> Software Updates> FIAT> Z-E3756
Link: http://www.zenec.com/support/software-updates/z-e3756/?lang=en

Download the Software Update “v1.8.6 “Z-E3756_FEU_v1.8.6.exe”.
The software package is a self-unzipping executable. Start extraction with a double-click and select your USB stick as target for the uncompressed files.
You obtain two files called „swupdate_6529B_20220815.zip” in the root directory of the USB stick
Connect the USB stick to the Z-E3756 USB-1 connection cable.
Go to the device menu:
Settings > System > Software Update and confirm by tapping on the green hook checkbox.
Tap on the green hook checkbox again, in the “Software Update?” pop-up window.
The update process starts automatically now.
The update installs sequentially and the lower part of the display screen informs about the progress. The software installation takes about 4~5 minutes.
Note: After successful installation, device reboot and shows the Tuner source.
Remove the USB stick.
Load factory
Note: After a successful update, the device menu language is in English. You can set the language to your preference as follows. Go to the device menu:
Setup > System > Load Factory and confirm by tapping the green hook checkbox.
Tap on the green hook check box again upon “Load Factory?” prompt by the pop- up window.

Please do not operate or switch off the device during the restart process (duration approx. 3 minutes).After restart, the tuner source OSD will show up.
Note: After the loading factory defaults, some personal settings must be set again (such as camera grid lines, audio settings etc.)
Language setting
After the update, the system language is set to English. You can now change the device language to your preference. Go to the device menu:
Setup > Misc > tap on OSD Language and select your preferred language in the list. Confirm your language selection by tapping on the green hook checkbox once more in the pop-up window.
Version control
After installing the software update a version check needs to be carried out. In the device menu:
Settings > System > Software Version Information.
Version: v1.8.6

If the version differs from the target version, install the update a new.

Improvements and Bugfixes

MAINSYSTEM

Improved system performance
Handbrake parking function logic change from previous parking cable usage to GPS-DR data usage
Added new ZENEC CaraControl (Board Control) feature
Video: https://www.youtube.com/watch?v=V-TXYh79jM0

TUNER