SERVER 07745 Express Pumps Instruction Manual
- June 5, 2024
- SERVER
Table of Contents
SERVER 07745 Express Pumps
ASSEMBLY
INSERT PINCH VALVE into pump housing.
INSTALL DOME
Slide loop of dome up the housing tube. Press dome into housing fully.
Ensure valve flap covers bottom opening.
INSERT DISCHARGE FITTING
into pump housing discharge tube. Place loop of fitting around peg on end of discharge tube to secure.
DISASSEMBLY
According to food and safety regulations, most foods must be stored and/or served at certain temperatures or they could become hazardous. Check with local food and safety regulators for specific guidelines. Server Products, Inc. cannot be responsible for the serving of a potentially hazardous product.
CLEANING
-
FLUSH & RINSE
all pump surfaces with hot water. Place lower end of pump into a container of hot water and operate pump until all remaining product is expelled and only hot water is discharged. -
DISASSEMBLE & CLEAN
all washable parts with soap and hot water. Use brush to clean any confined areas. -
RINSE
fully with clear water -
SANITIZE
all parts according to local sanitization requirements. All parts in contact with food must be sanitized. -
AIR DRY
all parts fully
MODEL 07745
- PART QTY DESCRIPTION
- 07798 1 LARGE PINCH VALVE
- 07399 1 PUMP DOME, BLUE
- 07744 1 PUMP HOUSING ASSEMBLY
- 07797 1 DISCHARGE FITTING, .394, LG
TROUBLESHOOTING
DIFFICULT TO ATTACH PARTS?
Wet parts with clean water to help fit
PRODUCT DOESN’T PUMP?
- Ensure pinch valve is inserted in housing.
- Ensure connector is snapped fully in place to fitment in pouch.
- Ensure pump is properly installed in unit.
- Clean pump thoroughly.
LIMITED WARRANTY
This Server product is backed by a two-year limited warranty against defects in materials and workmanship. See Server-Products.com for details
GENERAL SERVICE, REPAIR OR RETURNS
Before sending an item to Server Products, contact Customer Care to request a Return Authorization Number. The RA Number ensures proper processing and a prompt turnaround. Repaired units are typically shipped out within 48 hours of receipt. Merchandise returned for credit will incur a 20% restocking charge, must be less than 90 days old, and in unused (new) condition. Electrical parts (thermostats, heating elements, etc.) are not returnable. Servicing Cord: Specific tools are required for safe and proper power supply cord removal and installation. Repairs should be done by an OEM representative or qualified technician using a cord meeting code H05 RN-F requirements
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>