levenhuk MT40 Cooking Thermometer User Manual

: June 3, 2024
: levenhuk

Table of Contents

levenhuk MT40 Cooking Thermometer
overview
Using
Specifications
Care and maintenance
Battery safety instructions
Levenhuk International Lifetime Warranty
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

levenhuk MT40 Cooking Thermometer

levenhuk-MT40-Cooking-Thermometer-product

overview

levenhuk-MT40-Cooking-Thermometer-fig-1

°C/°F / CAL button
HOLD/MAX/MIN button
ALARM/SET button
LCD screen

Levenhuk Wezzer digital cooking thermometers are designed for the temperature measurement of various types of food and dishes during the cooking process

Clean the probe thoroughly before and after every use.

Using

Unfold the probe from its housing and the LCD will immediately display the temperature. Insert the tip of the probe at least 1cm into the measured material. The current temperature will be shown on the display (4). Wait a few seconds to let the temperature stabilize. Press (1) to change the temperature unit (Celsius, °C / Fahrenheit, °F). Press any button to turn on the backlight.

Capture the current temperature
Before withdrawing the probe from food, press (2) to hold the temperature reading.

MIN./MAX
temperature records. Press and hold (2). The max. temperature value will appear on the display. Press (2) again to display the min. temperature value. To reset the max. and min. temperature values, press and hold (2) for three seconds.

Thermometer calibration
Take a cup of water with ice and insert the probe into the cup so that the probe comes into contact with the ice. Hold (1) for three seconds until “CAL” is displayed on the screen. The temperature is automatically set to 0°C (32°F).

High temperature alarm
Press (3), then press (1)/(2) to set the value. Press (3) again to confirm. Suggested temperatures for various meat types and degrees of doneness:

levenhuk-MT40-Cooking-Thermometer-fig-2

Specifications

Operating temperature range, °C/°F –50… 300/–58… 572
Waterproof IP65
Probe/needle tip diameter, mm 3.5/1.7
Probe length, mm 130
Power supply 1pc CR2450 battery

The manufacturer reserves the right to make changes to the product range and specifications without prior notice

Care and maintenance

Never leave the thermoprobe inside a working oven or microwave, remove the device immediately after measuring the temperature. Keep the device away from open flames and hot surfaces. Always wear protective gloves during and after using the thermoprobe due to the risk of burns. After each usage, wash the steel probe in soapy or running water. Place the steel probe in hot water for a few minutes in order to sterilize it. The device is not dishwasher safe. Never use a damaged device. Use the device only for its intended purpose. The device is suitable for indoor use only. Strictly follow the instructions and do not disassemble or drop the device as it may result in a loss of functionality. Children should use the device under adult supervision only.

Battery safety instructions

Always purchase the correct size and grade of battery most suitable for the intended use. Always replace the whole set of batteries at one time; taking care not to mix old and new ones, or batteries of different types. Clean the battery contacts and also those of the device prior to battery installation. Make sure the batteries are installed correctly with regard to polarity (+ and –). Remove batteries from equipment that is not to be used for an extended period of time. Remove used batteries promptly. Never short-circuit batteries as this may lead to high temperatures, leakage, or explosion. Never heat batteries in order to revive them. Do not disassemble batteries. Remember to switch off devices after use. Keep batteries out of the reach of children, to avoid risk of ingestion, suffocation, or poisoning. Utilize used batteries as prescribed by your country’s laws.

Levenhuk International Lifetime Warranty

All Levenhuk telescopes, microscopes, binoculars, and other optical products, except for their accessories, carry a lifetime warranty against defects in materials and workmanship. A lifetime warranty is a guarantee on the lifetime of the product on the market. All Levenhuk accessories are warranted to be free of defects in materials and workmanship for six months from the purchase date. The warranty entitles you to the free repair or replacement of the Levenhuk product in any country where a Levenhuk office is located if all the warranty conditions are met. For further details, please visit: www.levenhuk.com/warranty If warranty problems arise, or if you need assistance in using your product, contact the local Levenhuk branch