catit 43725 Stainless Steel Flower Fountain User Manual

: June 3, 2024
: catit

Table of Contents

catit 43725 Stainless Steel Flower Fountain
SAFETY TIPS
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
- CONTENTS
- PARTS
- USAGE
INSTALACION
WEEKLY MAINTENANCE
ACCESSORIES
SPARE PARTS
TROUBLESHOOTING
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

catit 43725 Stainless Steel Flower Fountain

catit-43725-Stainless-Steel-Flower-Fountain-product-
image

SAFETY TIPS

INSTRUCTIONS PERTAIN- ING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS

IMPORTANT SAFETY INSTRUCTIONS

WARNING: To guard against injury, basic safety precautions should be observed, including the following:
READ AND FOLLOW ALL 1

SAFETY INSTRUCTIONS
and all the important notices on the appliance before using the pump. Failure to do so may result in damage to this appliance.
DANGER – To avoid possible electrical shock, special care should be taken since water is employed in the use of this product. For each of the following situations, do not attempt repairs yourself; return the pump to an authorized service facility for service if it is still under warranty or discard the appliance.
If the pump shows any sign of abnormal water leakage, dis-connect the power supply cord and remove pump from water.
Carefully examine the appliance after installation. It should not be plugged in if there is water on parts not intended to be wet.
Do not operate the appliance if it has a damaged electrical cord or plug, or if it is malfunctioning or if it is dropped or dam-aged in any manner. The power cord of this appliance cannot be replaced: if the cord is damaged, the appliance should be discarded. Never cut the cord.
The electrical outlet should always be above the level of the appliance. If the plug or outlet does get wet, DO NOT unplug the electrical cord. Disconnect the fuse or circuit breaker that supplies power to the appliance, then unplug and examine for presence of water in the outlet.
This appliance is not intended for use by persons (including children) with significantly impaired physical or mental capabilities, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children should always be supervised to ensure that they do not play with the appliance.
To avoid injury, do not contact moving or hot parts.
CAUTION Always unplug or disconnect the appliance from the outlet before putting on or taking off parts and while the equipment is being installed, maintained or handled. When inserting or removing the pump from the water, always pull out the main electrical plug. Never yank the cord to pull the plug from outlet. Grasp the plug and pull to disconnect. Always unplug an appliance from an outlet when not in use. Never lift the pump by the cord.
CAUTION:
THIS IS A PET DRINKING FOUNTAIN PUMP.
This pump has been evaluated for use with freshwater only. Do not use this pump for other than its intended use (i.e. don’t use in swimming pools, bath tubs, etc.). The use of attachments not recommended or sold by the appliance manufacturer may cause an unsafe condition.
- Do not use the pump in swimming pools or other situations where people are immersed.
- This pump is suitable for use in water temperatures up to 35ºC.
- Do not use this pump with inflammable liquids.
Do not install or store the appliance where it will be exposed to temperatures below freezing. Shelter the pump from direct sunlight.
Ensure that the appliance is placed on a flat, even surface. Monitor the appliance regularly. Do not leave appliance unat-tended for extended periods. Do not allow the pump to run dry. The pump must be immersed in water completely. This pump must never operate outside of water.
If an extension cord is necessary, ensure the connection is watertight and dust proof. A cord with a proper rating should be used. A cord rated for less amperes or watts than the appliance rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled.
Do not use this unit outdoors. This unit is for indoor use only.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

Only the faithful observation of these installation, electrical and maintenance guidelines will ensure the safe and efficient use of this drinking fountain.

RECYCLING:
This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European Directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment. Check with your local Environmental Agency for possible disposal instructions or take to an official council registered refuse collection point. Electronic products not included in the selective sorting process are potentially dangerous for the environment and human health due to the presence of hazardous substances.

PARTS

Pump cover with lever to regulate waterflow
Impeller Cap
Impeller
Pump

USAGE

Cats can be picky drinkers, some prefer large water surfaces over vertical streams and vice-versa. The Catit ® Flower Fountain TM provides your cat with a continuous indoor source of fresh, clean water and allows up to 3 different water flow settings to encourage your pet to drink more. Drinking more water helps ensure proper kidney function, helping to prevent crystal formation that can lead to urinary diseases.

INSTALACION

Remove unit from box. Remove poly bag from filter and set aside.
Clean fountain before using to remove any dirt or debris. Wash the complete unit (excluding the filter) with a sponge. Do not use abrasive cleansers or materials on any part of the unit. Rinse thoroughly.
Rinse filter to remove excess dust.
Open pump, remove impeller cap and impeller.
Rinse each part with water before carefully reassembling. Ensure flow adjuster is fully open.
Replace pump. Slide the lever to the side to increase the waterflow, slide the lever to the side to decrease the waterflow.
Re-thread power cord into groove in base.
Slide power cord holder into groove in base. Ensure notches on the outside tip of the power cord holder line up with notches on outside of base, then press down firmly to lock into position.
Replace filter holder.
Place filter on top of filter holder, and press down firmly.
Note: Install filter with foam-side facing up.
Replace stainless steel top.
Place fountain directly beneath faucet and fill.
The flower is easy to insert and remove from the fountain cover. Add the flower cap by pressing it down firmly onto the flower, remove it again by pushing the yellow rim upwards from below.
Allow the fountain to sit for 15 minutes before use. This allows the water to soak through the filter. Attach power cord to USB adapter, and plug in wall socket. Secure excess power cord with tie wrap and place behind unit to avoid pet chewing and entanglement.

WEEKLY MAINTENANCE

WARNING: Always unplug or disconnect the pump from the electrical supply with dry hands before putting on or taking off parts and whenever the pump is being installed, maintained or handled. Wash and rinse fountain with a soft sponge and a non-abrasive cleanser. Rinse thoroughly, ensuring no soapy residue. Remove the filter from the base and rinse. Do not wash the filter with soap. If filter contains excess debris or other foreign matter, replace it (replacement filters sold separately). The filter should be replaced every 3-4 weeks or when there are visible signs that the filter is saturated with foreign matter (debris, food, hair, etc.) or if the water flow is impeded. More frequent changes may be necessary due to indoor environmental and water conditions, as well as multiple pet use. Should pump appear dirty, open pump and remove impeller cap and impeller (p.17). Remove any debris from the impeller and clean impeller well with cotton swab. Handle impeller with care. If the pump makes noise, top up the water level in the pump chamber so it is fully submerged. DO NOT ALLOW THE PUMP TO RUN DRY.

ACCESSORIES

Triple Action Fountain Filter replacement filter pads available, sold separately.

SPARE PARTS

Pump with LED Nightlight and electrical cord (#50038) and USB Adapter (#50043)

CATIT FOR YOU
Discover helpful product information & manuals, participate in contests, and enjoy loads of spectacular benefits! Go to catit.com, select your country and go to Catit For You in the site menu.

REGISTER YOUR PRODUCT
To improve your access to our customer support, register your product online. Click the registration button on the Catit For You page and enter your product code, which is made up of the last 6 digits of your product’s barcode.

GETTING STARTED
Click the Getting Started button on the Catit For You page to find loads of ultra-handy guides and instruction videos that help you get your Catit product up and running in no time!

TROUBLESHOOTING

Experiencing an issue with a Catit product? Click the Troubleshooting button on the Catit For You page to find many handy blogs that might solve your problem.

CUSTOMER SERVICE
You couldn’t find the answer to your problem on the troubleshooting web page? Contact our customer service by clicking the Contact button in the site menu.

Distributed by

Germany: HAGEN Deutschland GmbH & Co. KG, 25488 Holm
Canada: Rolf C. Hagen Inc., Montréal (Quebec) H9X 0A2
U.S.A.: Rolf C. Hagen (U.S.A.) Corp., Mansfield, MA 02048
U.K.: Rolf C. Hagen (U.K.) Ltd., Castleford, W. Yorkshire WF10 5QH
Spain: Rolf C. Hagen España S.A., Av. de Beniparrell n.11 y 13, 46460 Silla, Valencia Malaysia: Rolf C. Hagen (SEA) Sdn Bhd 43200 Cheras, Selangor D.E.
Argentina: Hagen S.A. Argentina, Rutherford 4459, Malvinas Argentina – CP 1615, Pcia. Bs.As.
Made in Malaysia