catit 43747W Cat Drinking LED Flower Fountain User Manual

June 3, 2024
catit

catit 43747W Cat Drinking LED Flower Fountain

SAFETY TIPS
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS

IMPORTANT SAFETY INSTRUCTIONS

WARNING: To guard against injury, basic safety precautions should be observed, including the following:

  1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS and all the important notices on the appliance before using the pump. Failure to do so may result in damage to this appliance.

  2. DANGER – To avoid possible electrical shock, special care should be taken since water is employed in the use of this product. For each of the following situations, do not attempt repairs yourself; return the pump to an authorized service facility for service if it is still under warranty or discard the appliance.
    A. If the pump shows any sign of abnormal water leakage, disconnect the power supply cord and remove pump from water.
    B. Carefully examine the appliance after installation. It should not be plugged in if there is water on parts not intended to be wet.
    C. Do not operate the appliance if it has a damaged electrical cord or plug, or if it is malfunctioning or if it is dropped or damaged in any manner. The power cord of this appliance cannot be replaced: if the cord is damaged, the appliance should be discarded. Never cut the cord.
    D. The electrical outlet should always be above the level of the appliance. If the plug or outlet does get wet, DO NOT unplug the electrical cord. Disconnect the fuse or circuit breaker that supplies power to the appliance, then unplug and examine for presence of water in the outlet.

  3. This appliance is not intended for use by persons (including children) with significantly impaired physical or mental capabilities, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children should always be supervised to ensure that they do not play with the appliance.

  4. To avoid injury, do not contact moving or hot parts.

  5. CAUTION Always unplug or disconnect the appliance from the outlet before putting on or taking off parts and while the equipment is being installed, maintained or handled. When inserting or removing the pump from the water, always pull out the main electrical plug. Never yank the cord to pull the plug from outlet. Grasp the plug and pull to disconnect. Always unplug an appliance from an outlet when not in use. Never lift the pump by the cord.

  6. CAUTION:
    THIS IS A PET DRINKING FOUNTAIN PUMP.
    This pump has been evaluated for use with freshwater only. Do not use this pump for other than its intended use (i.e. don’t use in swimming pools, bathrooms, etc.). The use of attachments not recommended or sold by the appliance manufacturer may cause an unsafe condition.

    • Do not use the pump in swimming pools or other situations where people are immersed.
    • This pump is suitable for use in water temperatures up to 35ºC.
    • Do not use this pump with inflammable liquids.
  7. Do not install or store the appliance where it will be exposed to temperatures below freezing. Shelter the pump from direct sunlight.

  8. Ensure that the appliance is placed on a flat, even surface. Monitor the appliance regularly. Do not leave appliance unattended for extended periods. Do not allow the pump to run dry. The pump must be immersed in water completely. This pump must never operate outside of water.

  9. If an extension cord is necessary, ensure the connection is watertight and dustproof. A cord with a proper rating should be used. A cord rated for less amperes or watts than the appliance rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled.

  10. Do not use this unit outdoors. This unit is for indoor use only.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Only the faithful observation of this installation, electrical and maintenance guidelines will ensure the safe and efficient use of this drinking fountain.

RECYCLING: This symbol bears the selective sorting symbol for waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European Directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment. Check with your local Environmental Agency for possible disposal instructions or take to an official council-registered refuse collection point. Electronic products not included in the selective sorting process are potentially dangerous for the environment and human health due to the presence of hazardous substances.

CONTENTS

A. Cap
B. Flower
C. Fountainhead
D. Aktivkohle-Filter
E. Top
F. Base with Power Cord Holder
G. Pump with LED Nightlight and electrical cord
H. USB-Adapter

catit 43747W LED Flower Fountain-1

PARTS

  • A. Pump Cover
  • B. Impeller Cap
  • C. Impeller
  • D. Pump

USAGE

Cats can be picky drinkers, some prefer large water surfaces over vertical streams and vice-versa. The Catit ® Flower Fountain TM provides your cat with a continuous indoor source of fresh, clean water and allows up to 3 different water flow settings to encourage your pet to drink more. Drinking more water helps ensure proper kidney function, helping to prevent crystal formation that can lead to urinary diseases.

The Catit ® Flower Fountain TM allows up to 3 different water flow settings to encourage cats to drink more:

  1. Cuando se conecta sin accesorios, la Flower Fountain TM de Catit ® proporciona una superficie de agua que fluye suavemente.
  2. Inserting the flower accessory creates long, faucet-like streams of water. The flower is easy to add to (or remove from) the fountain.
  3. Adding the flowercap will tone down the bubbling water on top. Give this setting a try if your cat would rather play with the water than drink it.

Insertando el accesorio de la flor se crean corrientes largas, como un grifo. La flor es fácil de añadir o quitar de la fuente.

INSTALLATION

  1. Remove unit from box. Remove poly bag from filter and set aside.

  2. Clean fountain before using it to remove any dirt or debris. Wash the complete unit (excluding the filter) with a sponge. Do not use abrasive cleansers or materials on any part of the unit. Rinse thoroughly.

  3. Rinse filter to remove excess dust.

  4. Open pump, remove impeller cap and impeller. • Ouvrir la pompe, et retirer le couvercle de l’impulseur ainsi que l’impulseur.

  5. Rinse each part with water before carefully reassembling.
    Replace pump

  6. Re-thread power cord into groove in base.

  7. Slide power cord holder into groove in base. Ensure notches on the outside tip of the power cord holder line up with notches on outside of base, then press down firmly to lock into position.

  8. Replace top of fountain.

  9. Place filter on top of filter holder, and press down firmly. Note: Install filter with foam-side facing up.

  10. Replace fountainhead.

  11. Place fountain directly beneath faucet and fill.

  12. The flower is easy to insert and remove from the fountainhead. Add the flowercap by pressing it down firmly onto the flower, remove it again by pushing the yellow rim upwards from below.

  13. Allow the fountain to sit for 15 minutes before use. This allows the water to soak through the filter. Attach power cord to USB adapter, and plug in wall socket. Secure excess power cord with tie wrap and place behind unit to avoid pet chewing and entanglement.

WEEKLY MAINTENANCE

WARNING: Always unplug or disconnect the pump from the electrical supply with dry hands before putting on or taking off parts and whenever the pump is being installed, maintained or handled. Wash and rinse fountain with a soft sponge and a non-abrasive cleanser. Rinse thoroughly, ensuring no soapy residue. Remove the filter from the base and rinse. Do not wash the filter with soap. If filter contains excess debris or other foreign matter, replace it (replacement filters sold separately). The filter should be replaced every 3-4 weeks or when there are visible signs that the filter is saturated with foreign matter (debris, food, hair, etc.) or if the water flow is impeded. More frequent changes may be necessary due to indoor environmental and water conditions, as well as multiple pet use. Should pump appear dirty, open pump and remove impeller cap and impeller (p.19). Remove any debris from the impeller and clean impeller well with cotton swab. Handle impeller with care. If the pump makes noise, top up the water level in the pump chamber so it is fully submerged. DO NOT ALLOW THE PUMP TO RUN DRY.

WARRANTY

Your Catit® Flower FountainTM is guaranteed for defective parts and workmanship for a period of 2 years from the date of purchase. This guarantee is valid with proof of purchase only. The guarantee is limited to repair or replacement only and does not cover consequential loss, loss or damage to livestock and personal property or damage to animate or inanimate objects, irrespective of the cause thereof. This guarantee is valid only under normal operating conditions for which the unit is intended. It excludes any damage caused by unreasonable use, negligence, improper installation, tampering, abuse or commercial use. The warranty does not cover wear and tear or parts which have not been adequately or correctly maintained. THIS DOES NOT AFFECT YOUR STATUTORY RIGHTS.
For warranty service, contact your local pet product dealer or write to the Catit® representative in your country.
Please register your unique customer code online for additional access to customer service at www.catit.com.

ACCESSORIES

Triple Action Fountain Filter replacement filter pads available, sold separately.

Replace monthly
FREE reminder at catit.com

Germany: Hagen Deutschland GmbH & Co. KG, 25488 Holm
Canada: Rolf C. Hagen Inc., Montréal (Quebec) H9X 0A2
U.S.A.: Rolf C. Hagen (U.S.A.) Corp., Mansfield, MA 02048
U.K.: Rolf C. Hagen (U.K.) Ltd., Castleford, W. Yorkshire WF10 5QH
Spain: Rolf C. Hagen España S.A., Av. de Beniparrell n. 11 y 13, 46460 Silla, Valencia
Malaysia: Rolf C. Hagen (SEA) Sdn Bhd 43200 Cheras, Selangor D.E.
Argentina: Hagen S.A Argentina, Benjamín Seaver 5457 B1615MRC, Buenos Aires

SPARE PARTS
Pump with LED Nightlight and electrical cord (#50038) and USB Adapter (#50043)

Go to www.catit.com and fill in your unique code for special access to customer service, promotions and more!

Distributed by

Canada: Rolf C. Hagen Inc., Montréal (Quebec) H9X 0A2
U.S.A.: Rolf C. Hagen (U.S.A.) Corp., Mansfield, MA 02048
U.K.: Rolf C. Hagen (U.K.) Ltd., Castleford, W. Yorkshire WF10 5QH
Germany: Hagen Deutschland GmbH & Co. KG, 25488 Holm
Spain: Rolf C. Hagen España S.A., Av. de Beniparrell n. 11 y 13, 46460 Silla, Valencia
Malaysia: Rolf C. Hagen (SEA) Sdn Bhd 43200 Cheras, Selangor D.E.
Argentina: Hagen S.A Argentina, Benjamín Seaver 5457 B1615MRC, Buenos Aires
Made in Malaysia

MORE INFORMATION

CATIT.COM

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

catit User Manuals

Related Manuals