better bathrooms WPW2400 Waterproof Slat Wall Panelling Instruction Manual
- August 7, 2024
- Better Bathrooms
Table of Contents
better bathrooms WPW2400 Waterproof Slat Wall Panelling
Product Specifications
- Product Name: Waterproof Slat Wall Panelling
- Installation: Vertical, Horizontal, Diagonal
- Usage: Wall to Wall Installation
- Additional Feature: Edge Caps for Installation
Product Usage Instructions
- Installation Guide:
- To install the Waterproof Slat Wall Panelling, follow these steps:
- Secure the panels using suitable anchors for the surface.
- Choose between vertical, horizontal, or diagonal installation based on your preference.
- For wall-to-wall installation, ensure a secure fit.
- Installation Using Edge Caps:
- If you prefer using edge caps for installation, follow these steps:
- Right-tongue end cap for one side.
- Left-tongue end cap for the opposite side.
- Cleaning:
- To clean the paneling, use appropriate cleansing methods to maintain its waterproof properties.
FAQs
- Q: Can the Waterproof Slat Wall Panelling be used in wet areas?
- A: Yes, the paneling is waterproof and suitable for wet areas.
- Q: What anchors are recommended for installation?
- A: Suitable anchors for the specific surface should be used as per the installation guide.
GENERAL INFORMATION
- Panels should be installed with our waterproof Hybrid Grab Adhesive
- The Installer should have basic technical knowledge and be familiar with safety precautions
- Prior to installation lay the boards in the room where they are to be installed for 24 hours to adjust to room temperature
- End trims are available as an optional finishing detail
- Avoid areas of increased temperatures (above 60°C) such as a sauna, chimney or an area near a cooker for example.
- The product is only suitable for indoor applications.
- The product can be installed in damp areas, such as bathrooms.
- If installing in areas in direct contact with water the vertical edges and ends should be sealed with a sealant.
- Made from recyclable material.
- Any non-compliance with the instructions will void the product’s warranty
ADDITIONAL INFORMATION
- No additional weight should be applied to the boards and neither is it suitable as a weight bearing element in construction
- Hangers or shelves should not be screwed directly into the board
- Instead they should be mounted into the surface on which the board is mounted using suitable anchors for the surface.
TOOLS REQUIRED
- Pencil
- Tape Measure
- Spirit Level
- Hybrid Grab Adhesive
- Sealant Gun
- Clear Sanitary Silicone (For Wet Areas)
- Fine tooth saw
INSTALLATION OPTIONS
CUTTING PANELS
- Measure where you want to cut.
- Mark the panel with a pencil.
- Place the panel face up and cut along the line using a fine-toothed hand saw.
INSTALLATION WALL TO WALL
- Apply adhesive along the length of each raised ridge on the back of
- the panel
- Working left to right place the first panel with the tongue to the right
- Press firmly to adhere the panel to the wall.
- Continue the above process ensuring the panels overlap.
- Apply a clear silicone seal to the joint if the area is expected to be exposed to water.
- Wipe away any excess sealant before fixing the next panel.
Adhesive application
INSTALLATION USING EDGE CAPS
- Mark a vertical line using the spirit level
- Start on the left with the tongued end cap
- Apply the adhesive to the end cap and fix in place
- Continue left to right with the panels.
- Finish with a grooved end cap
CLEANING
- Clean the panels using a mild detergent
- Do not allow stains to dry
- Do not use water at a temperature of more than 40°C or strong detergents for cleaning as these may discolor the panels.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>