KUZCO MP28356 LED Multi-Pendant Installation Guide

KUZCO MP28356 LED Multi-Pendant

START FROM HERE

• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.

Technical Support: 1-855-855-8926

Please Note:

• These Kuzco LED fixtures come with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
• Use ELV (Electronic Low Voltage) type of dimmer for dimming application
• 120V input

OVERVIEW

1. Remove fixture from its original package
2. Pull magnetic plate (2k) off the bottom of the canopy (2a) to gain access
3. Attach canopy (2a) to electrical junction box (1a) using screws provided (1e) in the hardware package and then secure canopy (2a) to the mounting surface with additional screws (1h)
4. To change fixture height, push and hold the wire gripper (2g), slide the wire to the desired length, and then release the wire gripper (2g) to secure
5. Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in the hardware package
6. Fine tone wire length if necessary, by pushing and holding the wire gripper (2g) and then adjust the wire to the desired length
7. Loosely wrap extra wires around wire clips (2i) and close to secure
8. Close canopy (2a) by re-attaching magnetic plate (2k), make sure no electrical wires or support cables are in the way

19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196 W: kuzcolighting.com 20220323

References

• Kuzco Lighting – Modern Contemporary Lighting.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>