PEAK DESIGN M-CM-AA-BK-1 Mobile Magnetic Charging Car Mount User Guide
- June 5, 2024
- peak design
Table of Contents
**PEAK DESIGN M-CM-AA-BK-1 Mobile Magnetic Charging Car Mount User Guide
**
WHAT’S IN THE BOX
requires Peak Design Case or MagSafe Phone/Case not included
Allow 24 hours for Base
Plate to adhere to surface before use! REALLY!
Cable Clips x3
USB-C to USB-C Cable (1m)
Charging Port
Get started
INSTALLATION
Installation takes 24 hours!
-
Locate a spot on your dash or console to attach your Car Mount. For ideal adhesion, mount to a hard smooth car surface. Soft plastics and leathers with texture should be avoided to ensure a ideal bond.
Test fit to ensure the Base Plate can match the contours of the dash.
-
Clean surface with provided wipe.
Wait five minutes for the surface to dry. Not allowing surface to fully dry may result in failure to bond.
-
Remove adhesive backing and attach the Car Mount by pressing and holding firmly.
Press down firmly for 30 seconds on the Base Plate (not the Mount Head!).
Wait 24 hours before use. Failure to wait a full 24 hours will result in a weak bond. -
Repeat steps 2-3 to install Cable Clips routing the Cable to the Charging Port.
ADHESIVE FAILURE
In the event the adhesive fails, remove the adhesive from the mount using your
thumb by slowly peeling from the plastic base.
Apply a new adhesive pad to the base of the mount.
Install the mount again following the installation steps exactly.
WARNING: If not attached correctly, product and/or phone may dislodge or be thrown into air in event of crash. Consult your car’s manual to ensure mount does not cover or interfere with operation of airbag.
USE
Attaching Phone
Car Mount magnetically connects to the back of your phone. Requires Peak
Design Case or MagSafe Phone/Case. Once connected, confirm phone is charging
via phone screen.
Removing Mount
We recommend breaking the adhesive bond using dental floss. Wrap floss behind
mount and move down in a sawing motion.
Stay safe. Follow local regulations for phone use while driving.