peak design M-CM-AB-WEB-1 Magnetic Car Mount for Smartphone Instructions
- June 8, 2024
- peak design
Table of Contents
peak design M-CM-AB-WEB-1 Magnetic Car Mount for Smartphone
CAR MOUNT INSTRUCTIONS
- more info pkdsn.com/carmount
GET TO KNOW YOUR MOUNT
requires Peak Design Case or MagSafe Phone/Case not included
Allow 24 hours for Base Plate to adhere to surface before use! REALLY!
INSTALLATION
- Installation takes 24 hours!
- Locate a spot on your dash or console to attach your Car Mount. For ideal adhesion, mount to a hard, smooth, flat surface. Soft plastics and leathers with texture should be avoided to ensure a ideal bond. Test fit to ensure the Base Plate can match the contours of the dash.
- Clean surface with provided wipe.
Wait five minutes for the surface to dry. Not allowing surface to fully dry may result in failure to bond.
- Remove adhesive backing and attach the Car Mount by pressing and holding firmly.
- Wait five minutes for the surface to dry. Not allowing surface to fully dry may result in failure to bond.
- Wait 24 hours before use. Failure to wait a full 24 hours will result in a weak bond.
ADHESIVE FAILURE
In the event the adhesive fails, remove the adhesive from the mount using your
thumb by slowly peeling from the plastic base. Apply a new adhesive pad to the
base of the mount. Install the mount again following the installation steps
exactly.
USE
Attaching Phone
Car Mount magnetically connects to the back of your phone. Requires Peak
Design Case or MagSafe Phone/Case.
Removing Mount
We recommend breaking the adhesive bond using denta floss. Wrap floss behind
mount and cinch down.
Stay safe. Follow local regulations for phone use while driving.
WARNING: If not attached correctly, product and/or phone may dislodge or be thrown into air in event of crash. Consult your car’s manual to ensure mount does not cover or interfere with operation of airbag.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>