peak design M-CM-AA-WEB-1 Mobile Magnetic Charging Car Mount Instruction Manual
- June 8, 2024
- peak design
Table of Contents
peak design M-CM-AA-WEB-1 Mobile Magnetic Charging Car Mount
WIRELESS CHARGING CAR MOUNT
INSTRUCTIONS
GET TO KNOW YOUR MOUNT
requires Peak Design Case or Mag Safe Phone/Case not included
Car Mount
INSTALLATION
Installation takes 24 hours!
-
Locate a spot on your dash or console to attach your Car Mount.
For ideal adhesion, mount to a hard, smooth, flat surface.
Soft plastics and leathers with texture should be avoided to ensure a ideal bond.
Test fit to ensure the Base Plate can match the contours of the dash.
-
Clean surface with provided wipe.
Wait five minutes for the
surface to dry.
Not allowing surface to fully dry may result in failure to bond. -
Remove adhesive backing and attach the Car Mount by pressing and holding firmly.
Wait five minutes for the
surface to dry.
Not allowing surface to fully dry may result in failure to bond.
Wait 24 hours before use. Failure to wait a full 24 hours will result in a weak bond. -
Repeat steps 2-3 to install Cable Clips routing the Cable to the Charging Port.
ADHESIVE FAILURE
In the event the adhesive fails, remove the adhesive from the mount using your thumb by slowly peeling from the plastic base.
Apply a new adhesive pad to the base of the mount.
Install the mount again following the installation steps exactly.
USE
Attaching Phone
Car Mount magnetically connects to the back of your phone. Requires Peak
Design Case or Mag Safe Phone/Case.
Once connected, confirm phone is charging via phone screen.
Stay safe. Follow local regulations for phone use while driving.
Removing Mount
We recommend breaking the adhesive bond using dental floss.
Wrap floss behind mount and cinch down.
WARNING: If not attached correctly, product and/or phone may dislodge or
be thrown into air in event of crash.
Consult your car’s manual to ensure mount does not cover or interfere with
operation of airbag.