Peak-Design 2AZ94MCMAA Wireless Charging Car Mount User Manual
- June 5, 2024
- peak design
Table of Contents
Peak-Design 2AZ94MCMAA Wireless Charging Car Mount
FCC compliance statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designedto provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
ISED compliance statement
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
RF Exposure Compliance
This equipment complies with FCC/IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cmbetween the radiator and your body. Cet équipement est conforme aux limites d’exposition aux radiations FCC/IC CNR-102 établies pour un environnement non contrôlé. Cetéquipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.
EU
110.08-129.26kHz, H-field: -8.89dBuA/m@10m Hereby, Peak Design declares that
the radio equipment type M-CM-AA-BK-1, M-CM-AD-BK-1 \and M-CS-BK-1 are in
compliance with Directive2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
https://www.peakdesign.com/EU-certification Hereby, Peak Design declares
that the radio equipment type M-CM-AA-BK-1, M-CM-AD-BK-1and M-CS-BK-1 are in
compliance with UK Radio Equipment Regulations (SI 2017/1206). The full text
of the declaration of conformity is available at the following internet
address: https://www.peakdesign.com/EU-certification
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>