Maxxima MCL-3182400SN Double Ring Ceiling Light Instruction Manual
- June 3, 2024
- Maxxima
Table of Contents
Maxxima MCL-3182400SN Double Ring Ceiling Light
Double Ring Ceiling Light Installation Instructions
WARNINGS
- Risk of electric shock – Disconnect power at the source before installation.
- If you are unsure about the installation or the maintenance of the wall light, please consult an electrician.
- Do not make or alter any holes in the wiring enclosure or modify any electrical componentry.
CAUTIONS
- To insure personal safety, proper grounding of the electrical fixture is required.
- The fixture must be wired in accordance with the National Electric Code and applicable local codes or ordinances.
Model: MCL-3182400SN
INSTALLATION INSTRUCTIONS
Tools needed
Screwdriver, wire nuts, electrical tape
-
Shut off power at the circuit breaker or fuse before installation.
-
If you are replacing an existing fixture, remove and disconnect the old fixture first.
-
Expose the power supply wires from the junction box.
-
Connect the green fixture ground wire to the junction box ground (bare) wire by using a wire nut.
-
Connect the white fixture neutral wire to the junction box white neutral wire using a wire nut.
-
Connect the black fixture hot wire to the junction box hot wire from switch by using a wire nut.
-
Align the canopy base over the mounting screw holes on the junction box.
-
Thread the mounting screws through the slots in the canopy that align with the junction box mounting holes. Adjust the canopy until the screws are at the small end of the keyhole slots.
-
Ensure that the wires are placed properly within the junction box.
Tighten the mounting screws until the canopy base is snugly seated against the ceiling. -
Select a CCT located in the middle of the fixture.
-
Place the diffuser on the canopy. Then place the metal ring on the diffuser.
Let the 3 screws from the ring mount tubes protrude through the holes in the metal ring. -
Twist the 3 decorative nuts onto the ring mount tubes to secure the ring and diffuser.
-
The installation is complete. Restore power to the fixture and verify the fixture operates properly.
3 YEAR WARRANTY
Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.
info@maxximastyle.com
866-MAXXIMA (629-9462)
www.maxximastyle.com
125 Cabot Court Hauppauge, NY 11788
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>